U_BOOT_CMD(
i2c, 6, 1, do_i2c,
"I2C sub-system",
+ "speed [speed] - show or set I2C bus speed\n"
#if defined(CONFIG_I2C_MUX)
- "bus [muxtype:muxaddr:muxchannel] - add a new bus reached over muxes.\n"
+ "i2c bus [muxtype:muxaddr:muxchannel] - add a new bus reached over muxes\n"
#endif /* CONFIG_I2C_MUX */
- "speed [speed] - show or set I2C bus speed\n"
#if defined(CONFIG_I2C_MULTI_BUS)
"i2c dev [dev] - show or set current I2C bus\n"
#endif /* CONFIG_I2C_MULTI_BUS */
"i2c crc32 chip address[.0, .1, .2] count - compute CRC32 checksum\n"
"i2c probe - show devices on the I2C bus\n"
"i2c reset - re-init the I2C Controller\n"
- "i2c loop chip address[.0, .1, .2] [# of objects] - looping read of device\n"
+ "i2c loop chip address[.0, .1, .2] [# of objects] - looping read of device"
#if defined(CONFIG_CMD_SDRAM)
- "i2c sdram chip - print SDRAM configuration information\n"
+ "\n"
+ "i2c sdram chip - print SDRAM configuration information"
#endif
);