#include <asm/cpm_85xx.h>
#include <pci.h>
+#if defined(CONFIG_OF_FLAT_TREE)
+#include <ft_build.h>
+#endif
#if defined(CONFIG_PCI)
+static struct pci_controller *pci_hose;
-/*
- * Initialize PCI Devices, report devices found.
- */
-
-#ifndef CONFIG_PCI_PNP
-static struct pci_config_table pci_mpc85xxads_config_table[] = {
- {PCI_ANY_ID, PCI_ANY_ID, PCI_ANY_ID, PCI_ANY_ID,
- PCI_IDSEL_NUMBER, PCI_ANY_ID,
- pci_cfgfunc_config_device, {PCI_ENET0_IOADDR,
- PCI_ENET0_MEMADDR,
- PCI_COMMAND_MEMORY |
- PCI_COMMAND_MASTER}},
- {}
-};
-#endif
+void
+pci_mpc85xx_init(struct pci_controller *board_hose)
+{
+ u16 reg16;
+ u32 dev;
-struct pci_controller local_hose = {
-#ifndef CONFIG_PCI_PNP
- config_table: pci_mpc85xxads_config_table,
+ volatile immap_t *immap = (immap_t *)CFG_CCSRBAR;
+ volatile ccsr_pcix_t *pcix = &immap->im_pcix;
+#ifdef CONFIG_MPC85XX_PCI2
+ volatile ccsr_pcix_t *pcix2 = &immap->im_pcix2;
#endif
-};
-
+ volatile ccsr_gur_t *gur = &immap->im_gur;
+ struct pci_controller * hose;
-void pci_init_board (void)
-{
- struct pci_controller *hose = (struct pci_controller *) &local_hose;
- volatile immap_t *immap = (immap_t *) CFG_CCSRBAR;
- volatile ccsr_pcix_t *pcix = &immap->im_pcix;
+ pci_hose = board_hose;
- u16 reg16;
+ hose = &pci_hose[0];
hose->first_busno = 0;
hose->last_busno = 0xff;
- pci_set_region (hose->regions + 0,
- CFG_PCI1_MEM_BASE,
- CFG_PCI1_MEM_PHYS, CFG_PCI1_MEM_SIZE, PCI_REGION_MEM);
+ pci_setup_indirect(hose,
+ (CFG_IMMR+0x8000),
+ (CFG_IMMR+0x8004));
- pci_set_region (hose->regions + 1,
- CFG_PCI1_IO_BASE,
- CFG_PCI1_IO_PHYS, CFG_PCI1_IO_SIZE, PCI_REGION_IO);
-
- hose->region_count = 2;
-
- pci_setup_indirect (hose, (CFG_IMMR + 0x8000), (CFG_IMMR + 0x8004));
-
- pci_read_config_word (PCI_BDF (0, 0, 0), PCI_COMMAND, ®16);
+ /*
+ * Hose scan.
+ */
+ dev = PCI_BDF(hose->first_busno, 0, 0);
+ pci_hose_read_config_word (hose, dev, PCI_COMMAND, ®16);
reg16 |= PCI_COMMAND_SERR | PCI_COMMAND_MASTER | PCI_COMMAND_MEMORY;
- pci_write_config_word (PCI_BDF (0, 0, 0), PCI_COMMAND, reg16);
+ pci_hose_write_config_word(hose, dev, PCI_COMMAND, reg16);
/*
* Clear non-reserved bits in status register.
*/
- pci_write_config_word (PCI_BDF (0, 0, 0), PCI_STATUS, 0xffff);
- pci_write_config_byte (PCI_BDF (0, 0, 0), PCI_LATENCY_TIMER, 0x80);
+ pci_hose_write_config_word(hose, dev, PCI_STATUS, 0xffff);
+
+ if (!(gur->pordevsr & PORDEVSR_PCI)) {
+ /* PCI-X init */
+ if (CONFIG_SYS_CLK_FREQ < 66000000)
+ printf("PCI-X will only work at 66 MHz\n");
+
+ reg16 = PCI_X_CMD_MAX_SPLIT | PCI_X_CMD_MAX_READ
+ | PCI_X_CMD_ERO | PCI_X_CMD_DPERR_E;
+ pci_hose_write_config_word(hose, dev, PCIX_COMMAND, reg16);
+ }
- pcix->potar1 = (CFG_PCI1_MEM_BASE >> 12) & 0x000fffff;
- pcix->potear1 = 0x00000000;
- pcix->powbar1 = (CFG_PCI1_MEM_BASE >> 12) & 0x000fffff;
+ pcix->potar1 = (CFG_PCI1_MEM_BASE >> 12) & 0x000fffff;
+ pcix->potear1 = 0x00000000;
+ pcix->powbar1 = (CFG_PCI1_MEM_PHYS >> 12) & 0x000fffff;
pcix->powbear1 = 0x00000000;
- pcix->powar1 = 0x8004401c; /* 512M MEM space */
+ pcix->powar1 = (POWAR_EN | POWAR_MEM_READ |
+ POWAR_MEM_WRITE | (__ilog2(CFG_PCI1_MEM_SIZE) - 1));
- pcix->potar2 = (CFG_PCI1_IO_BASE >> 12) & 0x000fffff;
- pcix->potear2 = 0x00000000;
- pcix->powbar2 = (CFG_PCI1_IO_BASE >> 12) & 0x000fffff;
+ pcix->potar2 = (CFG_PCI1_IO_BASE >> 12) & 0x000fffff;
+ pcix->potear2 = 0x00000000;
+ pcix->powbar2 = (CFG_PCI1_IO_PHYS >> 12) & 0x000fffff;
pcix->powbear2 = 0x00000000;
- pcix->powar2 = 0x80088017; /* 16M IO space */
+ pcix->powar2 = (POWAR_EN | POWAR_IO_READ |
+ POWAR_IO_WRITE | (__ilog2(CFG_PCI1_IO_SIZE) - 1));
pcix->pitar1 = 0x00000000;
pcix->piwbar1 = 0x00000000;
- pcix->piwar1 = 0xa0F5501f;
+ pcix->piwar1 = (PIWAR_EN | PIWAR_PF | PIWAR_LOCAL |
+ PIWAR_READ_SNOOP | PIWAR_WRITE_SNOOP | PIWAR_MEM_2G);
+
+ pcix->powar3 = 0;
+ pcix->powar4 = 0;
+ pcix->piwar2 = 0;
+ pcix->piwar3 = 0;
+
+ pci_set_region(hose->regions + 0,
+ CFG_PCI1_MEM_BASE,
+ CFG_PCI1_MEM_PHYS,
+ CFG_PCI1_MEM_SIZE,
+ PCI_REGION_MEM);
+
+ pci_set_region(hose->regions + 1,
+ CFG_PCI1_IO_BASE,
+ CFG_PCI1_IO_PHYS,
+ CFG_PCI1_IO_SIZE,
+ PCI_REGION_IO);
+
+ hose->region_count = 2;
+
+ pci_register_hose(hose);
+
+#if defined(CONFIG_MPC8555CDS) || defined(CONFIG_MPC8541CDS)
+ /*
+ * This is a SW workaround for an apparent HW problem
+ * in the PCI controller on the MPC85555/41 CDS boards.
+ * The first config cycle must be to a valid, known
+ * device on the PCI bus in order to trick the PCI
+ * controller state machine into a known valid state.
+ * Without this, the first config cycle has the chance
+ * of hanging the controller permanently, just leaving
+ * it in a semi-working state, or leaving it working.
+ *
+ * Pick on the Tundra, Device 17, to get it right.
+ */
+ {
+ u8 header_type;
+
+ pci_hose_read_config_byte(hose,
+ PCI_BDF(0,BRIDGE_ID,0),
+ PCI_HEADER_TYPE,
+ &header_type);
+ }
+#endif
+
+ hose->last_busno = pci_hose_scan(hose);
+
+#ifdef CONFIG_MPC85XX_PCI2
+ hose = &pci_hose[1];
+
+ hose->first_busno = pci_hose[0].last_busno + 1;
+ hose->last_busno = 0xff;
+
+ pci_setup_indirect(hose,
+ (CFG_IMMR+0x9000),
+ (CFG_IMMR+0x9004));
+
+ dev = PCI_BDF(hose->first_busno, 0, 0);
+ pci_hose_read_config_word (hose, dev, PCI_COMMAND, ®16);
+ reg16 |= PCI_COMMAND_SERR | PCI_COMMAND_MASTER | PCI_COMMAND_MEMORY;
+ pci_hose_write_config_word(hose, dev, PCI_COMMAND, reg16);
+
+ /*
+ * Clear non-reserved bits in status register.
+ */
+ pci_hose_write_config_word(hose, dev, PCI_STATUS, 0xffff);
+
+ pcix2->potar1 = (CFG_PCI2_MEM_BASE >> 12) & 0x000fffff;
+ pcix2->potear1 = 0x00000000;
+ pcix2->powbar1 = (CFG_PCI2_MEM_PHYS >> 12) & 0x000fffff;
+ pcix2->powbear1 = 0x00000000;
+ pcix2->powar1 = (POWAR_EN | POWAR_MEM_READ |
+ POWAR_MEM_WRITE | (__ilog2(CFG_PCI2_MEM_SIZE) - 1));
+
+ pcix2->potar2 = (CFG_PCI2_IO_BASE >> 12) & 0x000fffff;
+ pcix2->potear2 = 0x00000000;
+ pcix2->powbar2 = (CFG_PCI2_IO_PHYS >> 12) & 0x000fffff;
+ pcix2->powbear2 = 0x00000000;
+ pcix2->powar2 = (POWAR_EN | POWAR_IO_READ |
+ POWAR_IO_WRITE | (__ilog2(CFG_PCI2_IO_SIZE) - 1));
+
+ pcix2->pitar1 = 0x00000000;
+ pcix2->piwbar1 = 0x00000000;
+ pcix2->piwar1 = (PIWAR_EN | PIWAR_PF | PIWAR_LOCAL |
+ PIWAR_READ_SNOOP | PIWAR_WRITE_SNOOP | PIWAR_MEM_2G);
+
+ pcix2->powar3 = 0;
+ pcix2->powar4 = 0;
+ pcix2->piwar2 = 0;
+ pcix2->piwar3 = 0;
+
+ pci_set_region(hose->regions + 0,
+ CFG_PCI2_MEM_BASE,
+ CFG_PCI2_MEM_PHYS,
+ CFG_PCI2_MEM_SIZE,
+ PCI_REGION_MEM);
+
+ pci_set_region(hose->regions + 1,
+ CFG_PCI2_IO_BASE,
+ CFG_PCI2_IO_PHYS,
+ CFG_PCI2_IO_SIZE,
+ PCI_REGION_IO);
+
+ hose->region_count = 2;
/*
* Hose scan.
*/
- pci_register_hose (hose);
- hose->last_busno = pci_hose_scan (hose);
+ pci_register_hose(hose);
+
+ hose->last_busno = pci_hose_scan(hose);
+#endif
}
+#ifdef CONFIG_OF_FLAT_TREE
+void
+ft_pci_setup(void *blob, bd_t *bd)
+{
+ u32 *p;
+ int len;
+
+ p = (u32 *)ft_get_prop(blob, "/" OF_SOC "/pci@8000/bus-range", &len);
+ if (p != NULL) {
+ p[0] = pci_hose[0].first_busno;
+ p[1] = pci_hose[0].last_busno;
+ }
+
+#ifdef CONFIG_MPC85XX_PCI2
+ p = (u32 *)ft_get_prop(blob, "/" OF_SOC "/pci@9000/bus-range", &len);
+ if (p != NULL) {
+ p[0] = pci_hose[1].first_busno;
+ p[1] = pci_hose[1].last_busno;
+ }
+#endif
+}
+#endif /* CONFIG_OF_FLAT_TREE */
#endif /* CONFIG_PCI */