}
/*
- * Adjust DDR II IO voltage biasing. It just makes it work.
+ * Adjust DDR II IO voltage biasing.
+ * Only 8548 rev 1 needs the fix
*/
- if (spd.mem_type == SPD_MEMTYPE_DDR2) {
- gur->ddrioovcr = (0
- | 0x80000000 /* Enable */
- | 0x10000000 /* VSEL to 1.8V */
- );
+ if ((SVR_VER(get_svr()) == SVR_8548_E) &&
+ (SVR_MJREV(get_svr()) == 1) &&
+ (spd.mem_type == SPD_MEMTYPE_DDR2)) {
+ gur->ddrioovcr = (0x80000000 /* Enable */
+ | 0x10000000);/* VSEL to 1.8V */
}
/*
* Is this an ECC DDR chip?
* But don't mess with it if the DDR controller will init mem.
*/
-#if defined(CONFIG_DDR_ECC) && !defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
+#ifdef CONFIG_DDR_ECC
if (spd.config == 0x02) {
+#ifndef CONFIG_ECC_INIT_VIA_DDRCONTROLLER
ddr->err_disable = 0x0000000d;
+#endif
ddr->err_sbe = 0x00ff0000;
}
+
debug("DDR: err_disable = 0x%08x\n", ddr->err_disable);
debug("DDR: err_sbe = 0x%08x\n", ddr->err_sbe);
-#endif
+#endif /* CONFIG_DDR_ECC */
asm("sync;isync;msync");
udelay(500);
break;
case 256:
case 512:
+ tlb_size = BOOKE_PAGESZ_256M;
+ break;
case 1024:
case 2048:
- tlb_size = BOOKE_PAGESZ_256M;
+ if (PVR_VER(get_pvr()) > PVR_VER(PVR_85xx))
+ tlb_size = BOOKE_PAGESZ_1G;
+ else
+ tlb_size = BOOKE_PAGESZ_256M;
break;
default:
puts("DDR: only 16M,32M,64M,128M,256M,512M,1G and 2G are supported.\n");
/*
* The memory was not able to be mapped.
+ * Default to a small size.
*/
- return 0;
+ tlb_size = BOOKE_PAGESZ_64M;
+ memsize=64;
break;
}