mpc8323erdb: Improve the system performance

[u-boot] / doc / README.nand

diff --git a/doc/README.nand b/doc/README.nand
index b5171f4d407c6d602100bb9b15993754d6d0c921..647a6b8e67fa7cf726b74a39f2df2a89d419330d 100644 (file)
--- a/doc/README.nand
+++ b/doc/README.nand
@@ -79,7 +79,7 @@ Commands:
 
    nand write.jffs2 addr ofs|partition size
       Like `write', but blocks that are marked bad are skipped and the
-      is written to the next block instead. This allows writing writing
+      data is written to the next block instead. This allows writing
       a JFFS2 image, as long as the image is short enough to fit even
       after skipping the bad blocks. Compact images, such as those
       produced by mkfs.jffs2 should work well, but loading an image copied
@@ -93,8 +93,8 @@ Commands:
 
 Configuration Options:
 
-   CFG_CMD_NAND
-      A good one to add to CONFIG_COMMANDS since it enables NAND support.
+   CONFIG_CMD_NAND
+      Enables NAND support and commmands.
 
    CONFIG_MTD_NAND_ECC_JFFS2
       Define this if you want the Error Correction Code information in
@@ -192,12 +192,7 @@ The old NAND handling code has been re-factored and is now confined
 to only board-specific files and - unfortunately - to the DoC code
 (see below). A new configuration variable has been introduced:
 CFG_NAND_LEGACY, which has to be defined in the board config file if
-that board uses legacy code. If CFG_NAND_LEGACY is defined, the board
-specific config.mk file should also have "BOARDLIBS =
-drivers/nand_legacy/libnand_legacy.a". For boards using the new NAND
-approach (PPChameleon and netstar at the moment) no variable is
-necessary, but the config.mk should have "BOARDLIBS =
-drivers/nand/libnand.a".
+that board uses legacy code.
 
 The necessary changes have been made to all affected boards, and no
 build breakage has been introduced, except for NETTA and NETTA_ISDN