sh: Renesas R0P7785LC0011RL board support

[u-boot] / doc / README.sh7785lcr

diff --git a/doc/README.sh7785lcr b/doc/README.sh7785lcr
new file mode 100644 (file)
index 0000000..0770276
--- /dev/null
+++ b/doc/README.sh7785lcr
@@ -0,0 +1,83 @@
+========================================
+Renesas Technology R0P7785LC0011RL board
+========================================
+
+This board specification:
+=========================
+
+The R0P7785LC0011RL(board config name:sh7785lcr) has the following device:
+
+ - SH7785 (SH-4A)
+ - DDR2-SDRAM 512MB
+ - NOR Flash 64MB
+ - 2D Graphic controller
+ - SATA controller
+ - Ethernet controller
+ - USB host/peripheral controller
+ - SD controller
+ - I2C controller
+ - RTC
+
+This board has 2 physical memory maps. It can be changed with DIP switch(S2-5).
+
+ phys address                  | S2-5 = OFF    | S2-5 = ON
+ -------------------------------+---------------+---------------
+ 0x00000000 - 0x03ffffff(CS0)  | NOR Flash     | NOR Flash
+ 0x04000000 - 0x05ffffff(CS1)  | PLD           | PLD
+ 0x06000000 - 0x07ffffff(CS1)  | reserved      | I2C
+ 0x08000000 - 0x0bffffff(CS2)  | USB           | DDR SDRAM
+ 0x0c000000 - 0x0fffffff(CS3)  | SD            | DDR SDRAM
+ 0x10000000 - 0x13ffffff(CS4)  | SM107         | SM107
+ 0x14000000 - 0x17ffffff(CS5)  | I2C           | USB
+ 0x18000000 - 0x1bffffff(CS6)  | reserved      | SD
+ 0x40000000 - 0x5fffffff       | DDR SDRAM     | (cannot use)
+
+
+This board specific command:
+============================
+
+This board has the following its specific command:
+
+ - hwtest
+ - printmac
+ - setmac
+
+
+1. hwtest
+
+This is self-check command. This command has the following options:
+
+ - all         : test all hardware
+ - pld         : output PLD version
+ - led         : turn on LEDs
+ - dipsw       : test DIP switch
+ - sm107       : output SM107 version
+ - net         : check RTL8110 ID
+ - sata                : check SiI3512 ID
+ - net         : output PCI slot device ID
+
+i.e)
+=> hwtest led
+turn on LEDs 3, 5, 7, 9
+turn on LEDs 4, 6, 8, 10
+
+=> hwtest net
+Ethernet OK
+
+
+2. printmac
+
+This command outputs MAC address of this board.
+
+i.e)
+=> printmac
+MAC = 00:00:87:**:**:**
+
+
+3. setmac
+
+This command writes MAC address of this board.
+
+i.e)
+=> setmac 00:00:87:**:**:**
+