doc: cleanup - move board READMEs into respective board directories

[u-boot] / doc / README.simpc8313

diff --git a/doc/README.simpc8313 b/doc/README.simpc8313
deleted file mode 100644 (file)
index b362c6a..0000000
--- a/doc/README.simpc8313
+++ /dev/null
@@ -1,80 +0,0 @@
-Sheldon Instruments SIMPC8313 Board
------------------------------------------
-
-1.     Board Switches and Jumpers
-
-       S2 is used to set CFG_RESET_SOURCE.
-
-       To boot the image in Large page NAND flash, use these DIP
-       switch settings for S2:
-
-       +----------+ ON
-       | * * **** |
-       |  * *     |
-       +----------+
-         12345678
-
-       To boot the image in Small page NAND flash, use these DIP
-       switch settings for S2:
-
-       +----------+ ON
-       | *** **** |
-       |    *     |
-       +----------+
-         12345678
-       (where the '*' indicates the position of the tab of the switch.)
-
-2.     Memory Map
-       The memory map looks like this:
-
-       0x0000_0000     0x1fff_ffff     DDR                     512M
-       0x8000_0000     0x8fff_ffff     PCI MEM                 256M
-       0x9000_0000     0x9fff_ffff     PCI_MMIO                256M
-       0xe000_0000     0xe00f_ffff     IMMR                    1M
-       0xe200_0000     0xe20f_ffff     PCI IO                  16M
-       0xe280_0000     0xe280_7fff     NAND FLASH (CS0)        32K
-       or
-       0xe280_0000     0xe281_ffff     NAND FLASH (CS0)        128K
-       0xff00_0000     0xff00_7fff     FPGA (CS1)              1M
-
-3.     Compilation
-
-       Assuming you're using BASH (or similar) as your shell:
-
-       export CROSS_COMPILE=your-cross-compiler-prefix-
-       make distclean
-       make SIMPC8313_LP_config
-       (or make SIMPC8313_SP_config, depending on the page size
-       of your NAND flash)
-       make
-
-4.     Downloading and Flashing Images
-
-4.1    Reflash U-boot Image using U-boot
-
-       =>run update_uboot
-
-       You may want to try
-       =>tftp $loadaddr $uboot
-       first, to make sure that the TFTP load will succeed before it
-       goes ahead and wipes out your current firmware.  And of course,
-       if the new u-boot doesn't boot, you can plug the board into
-       your PCI slot and with the supplied driver and sample app
-       you can reburn a working u-boot.
-
-4.2    Downloading and Booting Linux Kernel
-
-       Ensure that all networking-related environment variables are set
-       properly (including ipaddr, serverip, gatewayip (if needed),
-       netmask, ethaddr, eth1addr, fdtfile, and bootfile).
-
-       =>tftp $loadaddr uImage
-       =>nand write $loadaddr kernel $filesize
-       =>tftp $loadaddr $fdtfile
-       =>nand write $loadaddr 7e0000 1800
-
-       =>boot
-
-5      Notes
-
-       The console baudrate for SIMPC8313 is 115200bps.