#if defined(CONFIG_MX23)
uint32_t setreg = (uint32_t)(&apbh_regs->hw_apbh_ctrl0_set);
uint32_t offset = APBH_CTRL0_RESET_CHANNEL_OFFSET;
-#elif (defined(CONFIG_MX28) || defined(CONFIG_MX6))
+#elif (defined(CONFIG_MX28) || defined(CONFIG_MX6) || defined(CONFIG_MX7))
uint32_t setreg = (uint32_t)(&apbh_regs->hw_apbh_channel_ctrl_set);
uint32_t offset = APBH_CHANNEL_CTRL_RESET_CHANNEL_OFFSET;
#endif
return ret;
}
+/*
+ * Execute a continuously running circular DMA descriptor.
+ * NOTE: This is not intended for general use, but rather
+ * for the LCD driver in Smart-LCD mode. It allows
+ * continuous triggering of the RUN bit there.
+ */
+void mxs_dma_circ_start(int chan, struct mxs_dma_desc *pdesc)
+{
+ struct mxs_apbh_regs *apbh_regs =
+ (struct mxs_apbh_regs *)MXS_APBH_BASE;
+
+ mxs_dma_flush_desc(pdesc);
+
+ mxs_dma_enable_irq(chan, 1);
+
+ writel(mxs_dma_cmd_address(pdesc),
+ &apbh_regs->ch[chan].hw_apbh_ch_nxtcmdar);
+ writel(1, &apbh_regs->ch[chan].hw_apbh_ch_sema);
+ writel(1 << (chan + APBH_CTRL0_CLKGATE_CHANNEL_OFFSET),
+ &apbh_regs->hw_apbh_ctrl0_clr);
+}
+
/*
* Initialize the DMA hardware
*/