+// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2012-2013, Xilinx, Michal Simek
*
* (C) Copyright 2012
* Joe Hershberger <joe.hershberger@ni.com>
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
+#include <console.h>
#include <asm/io.h>
+#include <fs.h>
#include <zynqpl.h>
#include <linux/sizes.h>
#include <asm/arch/hardware.h>
#include <asm/arch/sys_proto.h>
#define DEVCFG_CTRL_PCFG_PROG_B 0x40000000
+#define DEVCFG_CTRL_PCFG_AES_EFUSE_MASK 0x00001000
#define DEVCFG_ISR_FATAL_ERROR_MASK 0x00740040
#define DEVCFG_ISR_ERROR_FLAGS_MASK 0x00340840
#define DEVCFG_ISR_RX_FIFO_OV 0x00040000
#define CONFIG_SYS_FPGA_PROG_TIME (CONFIG_SYS_HZ * 4) /* 4 s */
#endif
-static int zynq_info(xilinx_desc *desc)
-{
- return FPGA_SUCCESS;
-}
-
#define DUMMY_WORD 0xffffffff
/* Xilinx binary format header */
/* Setting PCFG_PROG_B signal to high */
control = readl(&devcfg_base->ctrl);
writel(control | DEVCFG_CTRL_PCFG_PROG_B, &devcfg_base->ctrl);
+
+ /*
+ * Delay is required if AES efuse is selected as
+ * key source.
+ */
+ if (control & DEVCFG_CTRL_PCFG_AES_EFUSE_MASK)
+ mdelay(5);
+
/* Setting PCFG_PROG_B signal to low */
writel(control & ~DEVCFG_CTRL_PCFG_PROG_B, &devcfg_base->ctrl);
+ /*
+ * Delay is required if AES efuse is selected as
+ * key source.
+ */
+ if (control & DEVCFG_CTRL_PCFG_AES_EFUSE_MASK)
+ mdelay(5);
+
/* Polling the PCAP_INIT status for Reset */
ts = get_timer(0);
while (readl(&devcfg_base->status) & DEVCFG_STATUS_PCFG_INIT) {
return FPGA_SUCCESS;
}
-static int zynq_dump(xilinx_desc *desc, const void *buf, size_t bsize)
+#if defined(CONFIG_CMD_FPGA_LOADFS)
+static int zynq_loadfs(xilinx_desc *desc, const void *buf, size_t bsize,
+ fpga_fs_info *fsinfo)
{
- return FPGA_FAIL;
+ unsigned long ts; /* Timestamp */
+ u32 isr_status, swap;
+ u32 partialbit = 0;
+ loff_t blocksize, actread;
+ loff_t pos = 0;
+ int fstype;
+ char *interface, *dev_part, *filename;
+
+ blocksize = fsinfo->blocksize;
+ interface = fsinfo->interface;
+ dev_part = fsinfo->dev_part;
+ filename = fsinfo->filename;
+ fstype = fsinfo->fstype;
+
+ if (fs_set_blk_dev(interface, dev_part, fstype))
+ return FPGA_FAIL;
+
+ if (fs_read(filename, (u32) buf, pos, blocksize, &actread) < 0)
+ return FPGA_FAIL;
+
+ if (zynq_validate_bitstream(desc, buf, bsize, blocksize, &swap,
+ &partialbit))
+ return FPGA_FAIL;
+
+ dcache_disable();
+
+ do {
+ buf = zynq_align_dma_buffer((u32 *)buf, blocksize, swap);
+
+ if (zynq_dma_transfer((u32)buf | 1, blocksize >> 2,
+ 0xffffffff, 0))
+ return FPGA_FAIL;
+
+ bsize -= blocksize;
+ pos += blocksize;
+
+ if (fs_set_blk_dev(interface, dev_part, fstype))
+ return FPGA_FAIL;
+
+ if (bsize > blocksize) {
+ if (fs_read(filename, (u32) buf, pos, blocksize, &actread) < 0)
+ return FPGA_FAIL;
+ } else {
+ if (fs_read(filename, (u32) buf, pos, bsize, &actread) < 0)
+ return FPGA_FAIL;
+ }
+ } while (bsize > blocksize);
+
+ buf = zynq_align_dma_buffer((u32 *)buf, blocksize, swap);
+
+ if (zynq_dma_transfer((u32)buf | 1, bsize >> 2, 0xffffffff, 0))
+ return FPGA_FAIL;
+
+ dcache_enable();
+
+ isr_status = readl(&devcfg_base->int_sts);
+
+ /* Check FPGA configuration completion */
+ ts = get_timer(0);
+ while (!(isr_status & DEVCFG_ISR_PCFG_DONE)) {
+ if (get_timer(ts) > CONFIG_SYS_FPGA_WAIT) {
+ printf("%s: Timeout wait for FPGA to config\n",
+ __func__);
+ return FPGA_FAIL;
+ }
+ isr_status = readl(&devcfg_base->int_sts);
+ }
+
+ debug("%s: FPGA config done\n", __func__);
+
+ if (!partialbit)
+ zynq_slcr_devcfg_enable();
+
+ return FPGA_SUCCESS;
}
+#endif
struct xilinx_fpga_op zynq_op = {
.load = zynq_load,
- .dump = zynq_dump,
- .info = zynq_info,
+#if defined(CONFIG_CMD_FPGA_LOADFS)
+ .loadfs = zynq_loadfs,
+#endif
};