help
This driver supports i.MX7ULP Rapid GPIO2P controller.
+config HSDK_CREG_GPIO
+ bool "HSDK CREG GPIO griver"
+ depends on DM_GPIO
+ default n
+ help
+ This driver supports CREG GPIOs on Synopsys HSDK SOC.
+
config LPC32XX_GPIO
bool "LPC32XX GPIO driver"
depends on DM
Support for PCF8575 I2C 16-bit GPIO expander. Most of these
chips are from NXP and TI.
+config RCAR_GPIO
+ bool "Renesas RCar GPIO driver"
+ depends on DM_GPIO && ARCH_RMOBILE
+ help
+ This driver supports the GPIO banks on Renesas RCar SoCs.
+
config ROCKCHIP_GPIO
bool "Rockchip GPIO driver"
depends on DM_GPIO
of 'anonymous' GPIOs that do not belong to any device or bank.
Select a suitable value depending on your needs.
+config CMD_TCA642X
+ bool "tca642x - Command to access tca642x state"
+ help
+ DEPRECATED - This needs conversion to driver model
+
+ This provides a way to looking at the pin state of this device.
+ This mirrors the 'gpio' command and that should be used in preference
+ to custom code.
+
config TEGRA_GPIO
bool "Tegra20..210 GPIO driver"
depends on DM_GPIO
Now, max 24 bits chips and PCA953X compatible chips are
supported
-config MPC85XX_GPIO
- bool "Freescale MPC85XX GPIO driver"
+config MPC8XXX_GPIO
+ bool "Freescale MPC8XXX GPIO driver"
depends on DM_GPIO
help
- This driver supports the built-in GPIO controller of MPC85XX CPUs.
+ This driver supports the built-in GPIO controller of MPC8XXX CPUs.
Each GPIO bank is identified by its own entry in the device tree,
i.e.
Aside from the standard functions of input/output mode, and output
value setting, the open-drain feature, which can configure individual
GPIOs to work as open-drain outputs, is supported.
-
- The driver has been tested on MPC85XX, but it is likely that other
- PowerQUICC III devices will work as well.
endmenu