can provide access to board-specific LEDs. Use of the device tree
for configuration is encouraged.
+config LED_BCM6328
+ bool "LED Support for BCM6328"
+ depends on LED && ARCH_BMIPS
+ help
+ This option enables support for LEDs connected to the BCM6328
+ LED HW controller accessed via MMIO registers.
+ HW blinking is supported and up to 24 LEDs can be controlled.
+ All LEDs can blink at the same time but the delay is shared, which
+ means that if one LED is set to blink at 100ms and then a different
+ LED is set to blink at 200ms, both will blink at 200ms.
+
+config LED_BCM6358
+ bool "LED Support for BCM6358"
+ depends on LED && ARCH_BMIPS
+ help
+ This option enables support for LEDs connected to the BCM6358
+ LED HW controller accessed via MMIO registers.
+ HW has no blinking capabilities and up to 32 LEDs can be controlled.
+
config LED_BLINK
bool "Support LED blinking"
depends on LED