usb: dwc3: Add DWC3 controller driver support

[u-boot] / drivers / mmc / omap_hsmmc.c

diff --git a/drivers/mmc/omap_hsmmc.c b/drivers/mmc/omap_hsmmc.c
index bada0066ecdfc57d0b697de81c2959a270a4a03c..8238a7e8e0087852cc05d882b5d32b60400efec0 100644 (file)
--- a/drivers/mmc/omap_hsmmc.c
+++ b/drivers/mmc/omap_hsmmc.c
@@ -134,13 +134,12 @@ static unsigned char mmc_board_init(struct mmc *mmc)
 
        pbias_lite = readl(&t2_base->pbias_lite);
        pbias_lite &= ~(PBIASLITEPWRDNZ1 | PBIASLITEPWRDNZ0);
-       writel(pbias_lite, &t2_base->pbias_lite);
-#endif
-#if defined(CONFIG_TWL4030_POWER)
-       twl4030_power_mmc_init();
-       mdelay(100);    /* ramp-up delay from Linux code */
+#ifdef CONFIG_TARGET_OMAP3_CAIRO
+       /* for cairo board, we need to set up 1.8 Volt bias level on MMC1 */
+       pbias_lite &= ~PBIASLITEVMODE0;
 #endif
-#if defined(CONFIG_OMAP34XX)
+       writel(pbias_lite, &t2_base->pbias_lite);
+
        writel(pbias_lite | PBIASLITEPWRDNZ1 |
                PBIASSPEEDCTRL0 | PBIASLITEPWRDNZ0,
                &t2_base->pbias_lite);
@@ -652,8 +651,7 @@ int omap_mmc_init(int dev_index, uint host_caps_mask, uint f_max, int cd_gpio,
        if (priv_data == NULL)
                return -1;
 
-       host_caps_val = MMC_MODE_4BIT | MMC_MODE_HS_52MHz | MMC_MODE_HS |
-                            MMC_MODE_HC;
+       host_caps_val = MMC_MODE_4BIT | MMC_MODE_HS_52MHz | MMC_MODE_HS;
 
        switch (dev_index) {
        case 0: