NAND initialization process.
config NAND_DENALI
- bool "Support Denali NAND controller"
+ bool
select SYS_NAND_SELF_INIT
imply CMD_NAND
- help
- Enable support for the Denali NAND controller.
config NAND_DENALI_DT
bool "Support Denali NAND controller as a DT device"
- depends on NAND_DENALI && OF_CONTROL && DM
+ select NAND_DENALI
+ depends on OF_CONTROL && DM
help
Enable the driver for NAND flash on platforms using a Denali NAND
controller as a DT device.
-config SYS_NAND_DENALI_64BIT
- bool "Use 64-bit variant of Denali NAND controller"
- depends on NAND_DENALI
- help
- The Denali NAND controller IP has some variations in terms of
- the bus interface. The DMA setup sequence is completely differenct
- between 32bit / 64bit AXI bus variants.
-
- If your Denali NAND controller is the 64-bit variant, say Y.
- Otherwise (32 bit), say N.
-
config NAND_DENALI_SPARE_AREA_SKIP_BYTES
int "Number of bytes skipped in OOB area"
depends on NAND_DENALI
config NAND_SUNXI
bool "Support for NAND on Allwinner SoCs"
- depends on MACH_SUN4I || MACH_SUN5I || MACH_SUN7I
+ depends on MACH_SUN4I || MACH_SUN5I || MACH_SUN7I || MACH_SUN8I
select SYS_NAND_SELF_INIT
select SYS_NAND_U_BOOT_LOCATIONS
+ select SPL_NAND_SUPPORT
imply CMD_NAND
---help---
Enable support for NAND. This option enables the standard and
config NAND_ARASAN
bool "Configure Arasan Nand"
+ select SYS_NAND_SELF_INIT
imply CMD_NAND
help
This enables Nand driver support for Arasan nand flash
config NAND_MXS
bool "MXS NAND support"
- depends on MX6 || MX7
+ depends on MX23 || MX28 || MX6 || MX7
imply CMD_NAND
+ select APBH_DMA
+ select APBH_DMA_BURST if ARCH_MX6 || ARCH_MX7
+ select APBH_DMA_BURST8 if ARCH_MX6 || ARCH_MX7
help
This enables NAND driver for the NAND flash controller on the
MXS processors.