#endif
/* XXX U-BOOT XXX */
-#if 0
+#ifdef CONFIG_CMD_NAND_LOCK_UNLOCK
+
/******************************************************************************
* Support for locking / unlocking operations of some NAND devices
*****************************************************************************/
* nand_lock: Set all pages of NAND flash chip to the LOCK or LOCK-TIGHT
* state
*
- * @param meminfo nand mtd instance
+ * @param mtd nand mtd instance
* @param tight bring device in lock tight mode
*
* @return 0 on success, -1 in case of error
* calls will fail. It is only posible to leave lock-tight state by
* an hardware signal (low pulse on _WP pin) or by power down.
*/
-int nand_lock(nand_info_t *meminfo, int tight)
+int nand_lock(struct mtd_info *mtd, int tight)
{
int ret = 0;
int status;
- struct nand_chip *this = meminfo->priv;
+ struct nand_chip *chip = mtd->priv;
/* select the NAND device */
- this->select_chip(meminfo, 0);
+ chip->select_chip(mtd, 0);
- this->cmdfunc(meminfo,
+ chip->cmdfunc(mtd,
(tight ? NAND_CMD_LOCK_TIGHT : NAND_CMD_LOCK),
-1, -1);
/* call wait ready function */
- status = this->waitfunc(meminfo, this, FL_WRITING);
+ status = chip->waitfunc(mtd, chip);
/* see if device thinks it succeeded */
if (status & 0x01) {
}
/* de-select the NAND device */
- this->select_chip(meminfo, -1);
+ chip->select_chip(mtd, -1);
return ret;
}
* nand_get_lock_status: - query current lock state from one page of NAND
* flash
*
- * @param meminfo nand mtd instance
+ * @param mtd nand mtd instance
* @param offset page address to query (muss be page aligned!)
*
* @return -1 in case of error
* NAND_LOCK_STATUS_UNLOCK: page unlocked
*
*/
-int nand_get_lock_status(nand_info_t *meminfo, ulong offset)
+int nand_get_lock_status(struct mtd_info *mtd, ulong offset)
{
int ret = 0;
int chipnr;
int page;
- struct nand_chip *this = meminfo->priv;
+ struct nand_chip *chip = mtd->priv;
/* select the NAND device */
- chipnr = (int)(offset >> this->chip_shift);
- this->select_chip(meminfo, chipnr);
+ chipnr = (int)(offset >> chip->chip_shift);
+ chip->select_chip(mtd, chipnr);
- if ((offset & (meminfo->writesize - 1)) != 0) {
+ if ((offset & (mtd->writesize - 1)) != 0) {
printf ("nand_get_lock_status: "
"Start address must be beginning of "
"nand page!\n");
}
/* check the Lock Status */
- page = (int)(offset >> this->page_shift);
- this->cmdfunc(meminfo, NAND_CMD_LOCK_STATUS, -1, page & this->pagemask);
+ page = (int)(offset >> chip->page_shift);
+ chip->cmdfunc(mtd, NAND_CMD_LOCK_STATUS, -1, page & chip->pagemask);
- ret = this->read_byte(meminfo) & (NAND_LOCK_STATUS_TIGHT
+ ret = chip->read_byte(mtd) & (NAND_LOCK_STATUS_TIGHT
| NAND_LOCK_STATUS_LOCK
| NAND_LOCK_STATUS_UNLOCK);
out:
/* de-select the NAND device */
- this->select_chip(meminfo, -1);
+ chip->select_chip(mtd, -1);
return ret;
}
* nand_unlock: - Unlock area of NAND pages
* only one consecutive area can be unlocked at one time!
*
- * @param meminfo nand mtd instance
+ * @param mtd nand mtd instance
* @param start start byte address
* @param length number of bytes to unlock (must be a multiple of
* page size nand->writesize)
*
* @return 0 on success, -1 in case of error
*/
-int nand_unlock(nand_info_t *meminfo, ulong start, ulong length)
+int nand_unlock(struct mtd_info *mtd, ulong start, ulong length)
{
int ret = 0;
int chipnr;
int status;
int page;
- struct nand_chip *this = meminfo->priv;
+ struct nand_chip *chip = mtd->priv;
printf ("nand_unlock: start: %08x, length: %d!\n",
(int)start, (int)length);
/* select the NAND device */
- chipnr = (int)(start >> this->chip_shift);
- this->select_chip(meminfo, chipnr);
+ chipnr = (int)(start >> chip->chip_shift);
+ chip->select_chip(mtd, chipnr);
/* check the WP bit */
- this->cmdfunc(meminfo, NAND_CMD_STATUS, -1, -1);
- if ((this->read_byte(meminfo) & 0x80) == 0) {
+ chip->cmdfunc(mtd, NAND_CMD_STATUS, -1, -1);
+ if (!(chip->read_byte(mtd) & NAND_STATUS_WP)) {
printf ("nand_unlock: Device is write protected!\n");
ret = -1;
goto out;
}
- if ((start & (meminfo->writesize - 1)) != 0) {
+ if ((start & (mtd->erasesize - 1)) != 0) {
printf ("nand_unlock: Start address must be beginning of "
- "nand page!\n");
+ "nand block!\n");
ret = -1;
goto out;
}
- if (length == 0 || (length & (meminfo->writesize - 1)) != 0) {
- printf ("nand_unlock: Length must be a multiple of nand page "
- "size!\n");
+ if (length == 0 || (length & (mtd->erasesize - 1)) != 0) {
+ printf ("nand_unlock: Length must be a multiple of nand block "
+ "size %08x!\n", mtd->erasesize);
ret = -1;
goto out;
}
+ /*
+ * Set length so that the last address is set to the
+ * starting address of the last block
+ */
+ length -= mtd->erasesize;
+
/* submit address of first page to unlock */
- page = (int)(start >> this->page_shift);
- this->cmdfunc(meminfo, NAND_CMD_UNLOCK1, -1, page & this->pagemask);
+ page = (int)(start >> chip->page_shift);
+ chip->cmdfunc(mtd, NAND_CMD_UNLOCK1, -1, page & chip->pagemask);
/* submit ADDRESS of LAST page to unlock */
- page += (int)(length >> this->page_shift) - 1;
- this->cmdfunc(meminfo, NAND_CMD_UNLOCK2, -1, page & this->pagemask);
+ page += (int)(length >> chip->page_shift);
+ chip->cmdfunc(mtd, NAND_CMD_UNLOCK2, -1, page & chip->pagemask);
/* call wait ready function */
- status = this->waitfunc(meminfo, this, FL_WRITING);
+ status = chip->waitfunc(mtd, chip);
/* see if device thinks it succeeded */
if (status & 0x01) {
/* there was an error */
out:
/* de-select the NAND device */
- this->select_chip(meminfo, -1);
+ chip->select_chip(mtd, -1);
return ret;
}
#endif
projects / u-boot / blobdiff