* (C) Copyright 2006 Detlev Zundel, dzu@denx.de
* (C) Copyright 2006 DENX Software Engineering
*
- * See file CREDITS for list of people who contributed to this
- * project.
- *
- * This program is free software; you can redistribute it and/or
- * modify it under the terms of the GNU General Public License as
- * published by the Free Software Foundation; either version 2 of
- * the License, or (at your option) any later version.
- *
- * This program is distributed in the hope that it will be useful,
- * but WITHOUT ANY WARRANTY; without even the implied warranty of
- * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
- * GNU General Public License for more details.
- *
- * You should have received a copy of the GNU General Public License
- * along with this program; if not, write to the Free Software
- * Foundation, Inc., 59 Temple Place, Suite 330, Boston,
- * MA 02111-1307 USA
+ * SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/io.h>
+#include <memalign.h>
#include <nand.h>
#include <asm/arch/clock.h>
#include <asm/arch/funcmux.h>
#include <asm/errno.h>
#include <asm/gpio.h>
#include <fdtdec.h>
+#include <bouncebuf.h>
#include "tegra_nand.h"
DECLARE_GLOBAL_DATA_PTR;
struct fdt_nand {
struct nand_ctlr *reg;
int enabled; /* 1 to enable, 0 to disable */
- struct fdt_gpio_state wp_gpio; /* write-protect GPIO */
+ struct gpio_desc wp_gpio; /* write-protect GPIO */
s32 width; /* bit width, normally 8 */
u32 timing[FDT_NAND_TIMING_COUNT];
};
struct nand_drv {
struct nand_ctlr *reg;
-
- /*
- * When running in PIO mode to get READ ID bytes from register
- * RESP_0, we need this variable as an index to know which byte in
- * register RESP_0 should be read.
- * Because common code in nand_base.c invokes read_byte function two
- * times for NAND_CMD_READID.
- * And our controller returns 4 bytes at once in register RESP_0.
- */
- int pio_byte_index;
struct fdt_nand config;
};
static struct mtd_info *our_mtd;
static struct nand_chip nand_chip[CONFIG_SYS_MAX_NAND_DEVICE];
-#ifdef CONFIG_SYS_DCACHE_OFF
-static inline void dma_prepare(void *start, unsigned long length,
- int is_writing)
-{
-}
-#else
-/**
- * Prepare for a DMA transaction
- *
- * For a write we flush out our data. For a read we invalidate, since we
- * need to do this before we read from the buffer after the DMA has
- * completed, so may as well do it now.
- *
- * @param start Start address for DMA buffer (should be cache-aligned)
- * @param length Length of DMA buffer in bytes
- * @param is_writing 0 if reading, non-zero if writing
- */
-static void dma_prepare(void *start, unsigned long length, int is_writing)
-{
- unsigned long addr = (unsigned long)start;
-
- length = ALIGN(length, ARCH_DMA_MINALIGN);
- if (is_writing)
- flush_dcache_range(addr, addr + length);
- else
- invalidate_dcache_range(addr, addr + length);
-}
-#endif
-
/**
* Wait for command completion
*
static uint8_t read_byte(struct mtd_info *mtd)
{
struct nand_chip *chip = mtd->priv;
- u32 dword_read;
struct nand_drv *info;
info = (struct nand_drv *)chip->priv;
- /* In PIO mode, only 4 bytes can be transferred with single CMD_GO. */
- if (info->pio_byte_index > 3) {
- info->pio_byte_index = 0;
- writel(CMD_GO | CMD_PIO
- | CMD_RX | CMD_CE0,
- &info->reg->command);
- if (!nand_waitfor_cmd_completion(info->reg))
- printf("Command timeout\n");
- }
+ writel(CMD_GO | CMD_PIO | CMD_RX | CMD_CE0 | CMD_A_VALID,
+ &info->reg->command);
+ if (!nand_waitfor_cmd_completion(info->reg))
+ printf("Command timeout\n");
- dword_read = readl(&info->reg->resp);
- dword_read = dword_read >> (8 * info->pio_byte_index);
- info->pio_byte_index++;
- return (uint8_t)dword_read;
+ return (uint8_t)readl(&info->reg->resp);
}
/**
case NAND_CMD_READID:
writel(NAND_CMD_READID, &info->reg->cmd_reg1);
writel(column & 0xFF, &info->reg->addr_reg1);
- writel(CMD_GO | CMD_CLE | CMD_ALE | CMD_PIO
- | CMD_RX |
- ((4 - 1) << CMD_TRANS_SIZE_SHIFT)
- | CMD_CE0,
- &info->reg->command);
- info->pio_byte_index = 0;
+ writel(CMD_GO | CMD_CLE | CMD_ALE | CMD_CE0,
+ &info->reg->command);
break;
case NAND_CMD_PARAM:
writel(NAND_CMD_PARAM, &info->reg->cmd_reg1);
| ((1 - 0) << CMD_TRANS_SIZE_SHIFT)
| CMD_CE0,
&info->reg->command);
- info->pio_byte_index = 0;
break;
case NAND_CMD_RESET:
writel(NAND_CMD_RESET, &info->reg->cmd_reg1);
char *tag_ptr;
struct nand_drv *info;
struct fdt_nand *config;
+ unsigned int bbflags;
+ struct bounce_buffer bbstate, bbstate_oob;
if ((uintptr_t)buf & 0x03) {
printf("buf %p has to be 4-byte aligned\n", buf);
stop_command(info->reg);
+ if (is_writing)
+ bbflags = GEN_BB_READ;
+ else
+ bbflags = GEN_BB_WRITE;
+
+ bounce_buffer_start(&bbstate, (void *)buf, 1 << chip->page_shift,
+ bbflags);
writel((1 << chip->page_shift) - 1, &info->reg->dma_cfg_a);
- writel(virt_to_phys(buf), &info->reg->data_block_ptr);
+ writel(virt_to_phys(bbstate.bounce_buffer), &info->reg->data_block_ptr);
+ /* Set ECC selection, configure ECC settings */
if (with_ecc) {
- writel(virt_to_phys(tag_ptr), &info->reg->tag_ptr);
if (is_writing)
memcpy(tag_ptr, chip->oob_poi + free->offset,
- chip->ecc.layout->oobavail +
- TAG_ECC_BYTES);
- } else {
- writel(virt_to_phys(chip->oob_poi), &info->reg->tag_ptr);
- }
-
- /* Set ECC selection, configure ECC settings */
- if (with_ecc) {
+ chip->ecc.layout->oobavail + TAG_ECC_BYTES);
tag_size = chip->ecc.layout->oobavail + TAG_ECC_BYTES;
reg_val |= (CFG_SKIP_SPARE_SEL_4
| CFG_SKIP_SPARE_ENABLE
if (!is_writing)
tag_size += SKIPPED_SPARE_BYTES;
- dma_prepare(tag_ptr, tag_size, is_writing);
+ bounce_buffer_start(&bbstate_oob, (void *)tag_ptr, tag_size,
+ bbflags);
} else {
tag_size = mtd->oobsize;
reg_val |= (CFG_SKIP_SPARE_DISABLE
| CFG_ECC_EN_TAG_DISABLE
| CFG_HW_ECC_DISABLE
| (tag_size - 1));
- dma_prepare(chip->oob_poi, tag_size, is_writing);
+ bounce_buffer_start(&bbstate_oob, (void *)chip->oob_poi,
+ tag_size, bbflags);
}
writel(reg_val, &info->reg->config);
-
- dma_prepare(buf, 1 << chip->page_shift, is_writing);
-
+ writel(virt_to_phys(bbstate_oob.bounce_buffer), &info->reg->tag_ptr);
writel(BCH_CONFIG_BCH_ECC_DISABLE, &info->reg->bch_config);
-
writel(tag_size - 1, &info->reg->dma_cfg_b);
nand_clear_interrupt_status(info->reg);
return -EIO;
}
+ bounce_buffer_stop(&bbstate_oob);
+ bounce_buffer_stop(&bbstate);
+
if (with_ecc && !is_writing) {
memcpy(chip->oob_poi, tag_ptr,
SKIPPED_SPARE_BYTES);
int tag_size;
struct nand_oobfree *free = chip->ecc.layout->oobfree;
struct nand_drv *info;
+ unsigned int bbflags;
+ struct bounce_buffer bbstate_oob;
if (((int)chip->oob_poi) & 0x03)
return -EINVAL;
stop_command(info->reg);
- writel(virt_to_phys(chip->oob_poi), &info->reg->tag_ptr);
-
/* Set ECC selection */
tag_size = mtd->oobsize;
if (with_ecc)
CFG_HW_ECC_DISABLE);
writel(reg_val, &info->reg->config);
- dma_prepare(chip->oob_poi, tag_size, is_writing);
-
- writel(BCH_CONFIG_BCH_ECC_DISABLE, &info->reg->bch_config);
-
if (is_writing && with_ecc)
tag_size -= TAG_ECC_BYTES;
+ if (is_writing)
+ bbflags = GEN_BB_READ;
+ else
+ bbflags = GEN_BB_WRITE;
+
+ bounce_buffer_start(&bbstate_oob, (void *)chip->oob_poi, tag_size,
+ bbflags);
+ writel(virt_to_phys(bbstate_oob.bounce_buffer), &info->reg->tag_ptr);
+
+ writel(BCH_CONFIG_BCH_ECC_DISABLE, &info->reg->bch_config);
+
writel(tag_size - 1, &info->reg->dma_cfg_b);
nand_clear_interrupt_status(info->reg);
return -EIO;
}
+ bounce_buffer_stop(&bbstate_oob);
+
if (with_ecc && !is_writing) {
reg_val = (u32)check_ecc_error(info->reg, 0, 0,
(u8 *)(chip->oob_poi + free->offset),
config->reg = (struct nand_ctlr *)fdtdec_get_addr(blob, node, "reg");
config->enabled = fdtdec_get_is_enabled(blob, node);
config->width = fdtdec_get_int(blob, node, "nvidia,nand-width", 8);
- err = fdtdec_decode_gpio(blob, node, "nvidia,wp-gpios",
- &config->wp_gpio);
+ err = gpio_request_by_name_nodev(blob, node, "nvidia,wp-gpios", 0,
+ &config->wp_gpio, GPIOD_IS_OUT);
if (err)
return err;
err = fdtdec_get_int_array(blob, node, "nvidia,timing",
nand->dev_ready = nand_dev_ready;
nand->priv = &nand_ctrl;
+ /* Disable subpage writes as we do not provide ecc->hwctl */
+ nand->options |= NAND_NO_SUBPAGE_WRITE;
+
/* Adjust controller clock rate */
clock_start_periph_pll(PERIPH_ID_NDFLASH, CLOCK_ID_PERIPH, 52000000);
/* Adjust timing for NAND device */
setup_timing(config->timing, info->reg);
- fdtdec_setup_gpio(&config->wp_gpio);
- gpio_direction_output(config->wp_gpio.gpio, 1);
+ dm_gpio_set_value(&config->wp_gpio, 1);
our_mtd = &nand_info[devnum];
our_mtd->priv = nand;