help
Enable Ethernet PHY (physical media interface) support.
+config RTL8211X_PHY_FORCE_MASTER
+ bool "Ethernet PHY RTL8211x: force 1000BASE-T master mode"
+ depends on PHYLIB
+ help
+ Force master mode for 1000BASE-T on RTl8211x PHYs (except for RTL8211F).
+ This can work around link stability and data corruption issues on gigabit
+ links which can occur in slave mode on certain PHYs, e.g. on the
+ RTL8211C(L).
+
+ Please note that two directly connected devices (i.e. via crossover cable)
+ will not be able to establish a link between each other if they both force
+ master mode. Multiple devices forcing master mode when connected by a
+ network switch do not pose a problem as the switch configures its affected
+ ports into slave mode.
+
+ This option only affects gigabit links. If you must establish a direct
+ connection between two devices which both force master mode, try forcing
+ the link speed to 100MBit/s.
+
+ If unsure, say N.
+
menuconfig NETDEVICES
bool "Network device support"
depends on NET
100Mbit and 1 Gbit operation. You must enable CONFIG_PHYLIB to
provide the PHY (physical media interface).
+config MVPP2
+ bool "Marvell Armada 375 network interface support"
+ depends on ARMADA_375
+ select PHYLIB
+ help
+ This driver supports the network interface units in the
+ Marvell ARMADA 375 SoC.
+
config PCH_GBE
bool "Intel Platform Controller Hub EG20T GMAC driver"
depends on DM_ETH && DM_PCI
This MAC is present in Intel Platform Controller Hub EG20T. It
supports 10/100/1000 Mbps operation.
+config RTL8139
+ bool "Realtek 8139 series Ethernet controller driver"
+ help
+ This driver supports Realtek 8139 series fast ethernet family of
+ PCI chipsets/adapters.
+
+config RTL8169
+ bool "Realtek 8169 series Ethernet controller driver"
+ help
+ This driver supports Realtek 8169 series gigabit ethernet family of
+ PCI/PCIe chipsets/adapters.
+
config XILINX_AXIEMAC
depends on DM_ETH && (MICROBLAZE || ARCH_ZYNQ || ARCH_ZYNQMP)
select PHYLIB