#define __REG(x) (*((volatile u32 *)(x)))
-#ifdef CONFIG_SYS_MX31_UART1
+#if defined(CONFIG_SYS_MX31_UART1) || defined(CONFIG_SYS_MX25_UART1)
#define UART_PHYS 0x43f90000
-#elif defined(CONFIG_SYS_MX31_UART2)
+#elif defined(CONFIG_SYS_MX31_UART2) || defined(CONFIG_SYS_MX25_UART2)
#define UART_PHYS 0x43f94000
-#elif defined(CONFIG_SYS_MX31_UART3)
+#elif defined(CONFIG_SYS_MX31_UART3) || defined(CONFIG_SYS_MX25_UART3)
#define UART_PHYS 0x5000c000
-#elif defined(CONFIG_SYS_MX31_UART4)
+#elif defined(CONFIG_SYS_MX31_UART4) || defined(CONFIG_SYS_MX25_UART4)
#define UART_PHYS 0x43fb0000
-#elif defined(CONFIG_SYS_MX31_UART5)
+#elif defined(CONFIG_SYS_MX31_UART5) || defined(CONFIG_SYS_MX25_UART5)
#define UART_PHYS 0x43fb4000
#elif defined(CONFIG_SYS_MX27_UART1)
#define UART_PHYS 0x1000a000
#define UART_PHYS 0x1001b000
#elif defined(CONFIG_SYS_MX27_UART6)
#define UART_PHYS 0x1001c000
+#elif defined(CONFIG_SYS_MX51_UART1)
+#define UART_PHYS UART1_BASE_ADDR
+#elif defined(CONFIG_SYS_MX51_UART2)
+#define UART_PHYS UART2_BASE_ADDR
+#elif defined(CONFIG_SYS_MX51_UART3)
+#define UART_PHYS UART3_BASE_ADDR
#else
-#error "define CONFIG_SYS_MX31_UARTx to use the mx31 UART driver"
+#error "define CONFIG_SYS_MXxx_UARTx to use the MXC UART driver"
+#endif
+
+#ifdef CONFIG_SERIAL_MULTI
+#warning "MXC driver does not support MULTI serials."
#endif
/* Register definitions */
void serial_setbrg (void)
{
-#ifdef CONFIG_MX31
- u32 clk = mx31_get_ipg_clk();
-#else
- u32 clk = imx_get_perclk1();
-#endif
+ u32 clk = imx_get_uartclk();
if (!gd->baudrate)
gd->baudrate = CONFIG_BAUDRATE;