mx28evk: add SPI support

[u-boot] / include / configs / BC3450.h

diff --git a/include/configs/BC3450.h b/include/configs/BC3450.h
index 4fbcb7d7ed8f8b397a97574772ca49f714b55bfa..8a73a9a4c08f39ccdd7eaefd7d2a0f7d6b3ce898 100644 (file)
--- a/include/configs/BC3450.h
+++ b/include/configs/BC3450.h
@@ -68,9 +68,6 @@
 
 #define CONFIG_SYS_MPC5XXX_CLKIN       33000000 /* ... running at 33.000000MHz     */
 
-#define BOOTFLAG_COLD          0x01    /* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM          0x02    /* Software reboot                  */
-
 #define CONFIG_HIGH_BATS       1       /* High BATs supported              */
 
 /*
@@ -109,7 +106,6 @@
 #define CONFIG_PCI_IO_PHYS     CONFIG_PCI_IO_BUS
 #define CONFIG_PCI_IO_SIZE     0x01000000
 
-#define CONFIG_NET_MULTI       1
 /*#define CONFIG_EEPRO100      XXX - FIXME: conflicts when CONFIG_MII is enabled */
 #define CONFIG_SYS_RX_ETH_BUFFER       8       /* use 8 rx buffer on eepro100  */
 #define CONFIG_NS8382X         1
@@ -387,13 +383,12 @@
 #define CONFIG_SYS_INIT_RAM_ADDR       MPC5XXX_SRAM
 #ifdef CONFIG_POST
 /* preserve space for the post_word at end of on-chip SRAM */
-# define CONFIG_SYS_INIT_RAM_END       MPC5XXX_SRAM_POST_SIZE
+# define CONFIG_SYS_INIT_RAM_SIZE      MPC5XXX_SRAM_POST_SIZE
 #else
-# define CONFIG_SYS_INIT_RAM_END       MPC5XXX_SRAM_SIZE
+# define CONFIG_SYS_INIT_RAM_SIZE      MPC5XXX_SRAM_SIZE
 #endif /*CONFIG_POST*/
 
-#define CONFIG_SYS_GBL_DATA_SIZE       128     /* Bytes reserved for initial data  */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
 #define CONFIG_SYS_MONITOR_BASE        CONFIG_SYS_TEXT_BASE