nitrogen6x: config: add gpio command

[u-boot] / include / configs / BSC9132QDS.h

diff --git a/include/configs/BSC9132QDS.h b/include/configs/BSC9132QDS.h
index 1b119f1f22eb3f815ceb039e61754c8ff7a24c24..aeded6d85b40c436998a39f5036525210d07cb09 100644 (file)
--- a/include/configs/BSC9132QDS.h
+++ b/include/configs/BSC9132QDS.h
@@ -41,7 +41,6 @@
 #endif
 
 #ifdef CONFIG_NAND
-#define CONFIG_SPL
 #define CONFIG_SPL_INIT_MINIMAL
 #define CONFIG_SPL_SERIAL_SUPPORT
 #define CONFIG_SPL_NAND_SUPPORT
@@ -354,13 +353,13 @@ combinations. this should be removed later
 #define CONFIG_SYS_CS2_FTIM1           (FTIM1_GPCM_TACO(0x0e) | \
                                        FTIM1_GPCM_TRAD(0x1f))
 #define CONFIG_SYS_CS2_FTIM2           (FTIM2_GPCM_TCS(0x0e) | \
-                                       FTIM2_GPCM_TCH(0x0) | \
+                                       FTIM2_GPCM_TCH(0x8) | \
                                        FTIM2_GPCM_TWP(0x1f))
 #define CONFIG_SYS_CS2_FTIM3           0x0
 #endif
 
 /* Set up IFC registers for boot location NOR/NAND */
-#if defined(CONFIG_NAND)
+#if defined(CONFIG_NAND) || defined(CONFIG_NAND_SECBOOT)
 #define CONFIG_SYS_CSPR0               CONFIG_SYS_NAND_CSPR
 #define CONFIG_SYS_AMASK0              CONFIG_SYS_NAND_AMASK
 #define CONFIG_SYS_CSOR0               CONFIG_SYS_NAND_CSOR
@@ -403,7 +402,7 @@ combinations. this should be removed later
                                                - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
-#define CONFIG_SYS_MONITOR_LEN         (256 * 1024) /* Reserve 256 kB for Mon*/
+#define CONFIG_SYS_MONITOR_LEN         (768 * 1024)
 #define CONFIG_SYS_MALLOC_LEN          (1024 * 1024)   /* Reserved for malloc*/
 
 /* Serial Port */