arm/km: add kmcoge5un board support

[u-boot] / include / configs / G2000.h

diff --git a/include/configs/G2000.h b/include/configs/G2000.h
index 2865b8496694a99f6eab6e1917cdb1bf00379431..08ba8404bf8c88efc639edec913c83bc669db71b 100644 (file)
--- a/include/configs/G2000.h
+++ b/include/configs/G2000.h
@@ -80,7 +80,6 @@
 
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change        */
 
-#define CONFIG_NET_MULTI       1
 
 #define CONFIG_PPC4xx_EMAC
 #define CONFIG_MII             1       /* MII PHY management           */
@@ -131,9 +130,6 @@
 #define CONFIG_SYS_PROMPT      "=> "           /* Monitor Command Prompt       */
 
 #undef CONFIG_SYS_HUSH_PARSER                  /* use "hush" command parser    */
-#ifdef CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2     "> "
-#endif
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_SYS_CBSIZE      1024            /* Console I/O Buffer Size      */
@@ -354,10 +350,9 @@
 #define CONFIG_SYS_OCM_DATA_ADDR       0xF8000000
 #define CONFIG_SYS_OCM_DATA_SIZE       0x1000
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_OCM_DATA_ADDR /* inside of SDRAM             */
-#define CONFIG_SYS_INIT_RAM_END        CONFIG_SYS_OCM_DATA_SIZE /* End of used area in RAM     */
+#define CONFIG_SYS_INIT_RAM_SIZE       CONFIG_SYS_OCM_DATA_SIZE /* Size of used area in RAM    */
 
-#define CONFIG_SYS_GBL_DATA_SIZE      128  /* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET    (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_GBL_DATA_OFFSET    (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
 /*-----------------------------------------------------------------------
@@ -382,14 +377,6 @@
 #define CONFIG_SYS_GPIO0_TSRH          0x00000000
 #define CONFIG_SYS_GPIO0_TCR           0xF7FF8014
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD  0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM  0x02            /* Software reboot                      */
-
 /*
  * Default speed selection (cpu_plb_opb_ebc) in mhz.
  * This value will be set if iic boot eprom is disabled.