DaVinci DM6467: Enhance board Support

[u-boot] / include / configs / MPC832XEMDS.h

diff --git a/include/configs/MPC832XEMDS.h b/include/configs/MPC832XEMDS.h
index bed62bd6eb4304509cf5063490fc90625dd30f03..affa3a9cf8dacf3e5dc00ccfd6104f7c42e669e0 100644 (file)
--- a/include/configs/MPC832XEMDS.h
+++ b/include/configs/MPC832XEMDS.h
@@ -28,8 +28,8 @@
 #define CONFIG_MPC83xx         1       /* MPC83xx family */
 #define CONFIG_MPC832x         1       /* MPC832x CPU specific */
 #define CONFIG_MPC832XEMDS     1       /* MPC832XEMDS board specific */
-#undef CONFIG_PQ_MDS_PIB /* POWERQUICC MDS Platform IO Board */
-#undef CONFIG_PQ_MDS_PIB_ATM   /* QOC3 ATM card */
+
+#define        CONFIG_SYS_TEXT_BASE    0xFE000000
 
 /*
  * System Clock Setup
@@ -135,7 +135,7 @@
 /*
  * The reserved memory
  */
-#define CONFIG_SYS_MONITOR_BASE        TEXT_BASE       /* start of monitor */
+#define CONFIG_SYS_MONITOR_BASE        CONFIG_SYS_TEXT_BASE    /* start of monitor */
 
 #if (CONFIG_SYS_MONITOR_BASE < CONFIG_SYS_FLASH_BASE)
 #define CONFIG_SYS_RAMBOOT
@@ -152,9 +152,8 @@
  */
 #define CONFIG_SYS_INIT_RAM_LOCK       1
 #define CONFIG_SYS_INIT_RAM_ADDR       0xE6000000      /* Initial RAM address */
-#define CONFIG_SYS_INIT_RAM_END        0x1000          /* End of used area in RAM */
-#define CONFIG_SYS_GBL_DATA_SIZE       0x100           /* num bytes initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE       0x1000          /* Size of used area in RAM */
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 
 /*
  * Local Bus Configuration & Clock Setup
@@ -526,14 +525,6 @@
 #define CONFIG_SYS_DBAT7U      CONFIG_SYS_IBAT7U
 #endif
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD  0x01    /* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM  0x02    /* Software reboot */
-
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed of kgdb serial port */
 #define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */