#ifndef __CONFIG_H
#define __CONFIG_H
-#undef DEBUG
-
/*
* High Level Configuration Options
*/
#define CFG_83XX_DDR_USES_CS0
-#undef CONFIG_DDR_ECC /* support DDR ECC function */
-#undef CONFIG_DDR_ECC_CMD /* Use DDR ECC user commands */
+#define CONFIG_DDR_ECC /* support DDR ECC function */
+#define CONFIG_DDR_ECC_CMD /* Use DDR ECC user commands */
/*
* DDRCDR - DDR Control Driver Register
*/
#define CONFIG_DDR_II
#define CFG_DDR_SIZE 256 /* MB */
-#define CFG_DDRCDR 0x80080001
#define CFG_DDR_CS0_BNDS 0x0000000f
#define CFG_DDR_CS0_CONFIG (CSCONFIG_EN | CSCONFIG_ROW_BIT_13 | \
- CSCONFIG_COL_BIT_10)
-#define CFG_DDR_TIMING_0 0x00330903
-#define CFG_DDR_TIMING_1 0x3835a322
-#define CFG_DDR_TIMING_2 0x00104909
-#define CFG_DDR_TIMING_3 0x00000000
-#define CFG_DDR_CLK_CNTL 0x02000000
+ CSCONFIG_COL_BIT_10 | CSCONFIG_ODT_WR_ACS)
+#define CFG_DDR_SDRAM_CFG (SDRAM_CFG_SDRAM_TYPE_DDR2 | SDRAM_CFG_ECC_EN)
+#define CFG_DDR_SDRAM_CFG2 0x00001000
+#define CFG_DDR_CLK_CNTL (DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05)
+#define CFG_DDR_INTERVAL ((256 << SDRAM_INTERVAL_BSTOPRE_SHIFT) | \
+ (1115 << SDRAM_INTERVAL_REFINT_SHIFT))
#define CFG_DDR_MODE 0x47800432
#define CFG_DDR_MODE2 0x8000c000
-#define CFG_DDR_INTERVAL 0x045b0100
-#define CFG_DDR_SDRAM_CFG 0x03000000
-#define CFG_DDR_SDRAM_CFG2 0x00001000
+
+#define CFG_DDR_TIMING_0 ((2 << TIMING_CFG0_MRS_CYC_SHIFT) | \
+ (9 << TIMING_CFG0_ODT_PD_EXIT_SHIFT) | \
+ (3 << TIMING_CFG0_PRE_PD_EXIT_SHIFT) | \
+ (3 << TIMING_CFG0_ACT_PD_EXIT_SHIFT) | \
+ (0 << TIMING_CFG0_WWT_SHIFT) | \
+ (0 << TIMING_CFG0_RRT_SHIFT) | \
+ (0 << TIMING_CFG0_WRT_SHIFT) | \
+ (0 << TIMING_CFG0_RWT_SHIFT))
+
+#define CFG_DDR_TIMING_1 (( TIMING_CFG1_CASLAT_30) | \
+ ( 2 << TIMING_CFG1_WRTORD_SHIFT) | \
+ ( 2 << TIMING_CFG1_ACTTOACT_SHIFT) | \
+ ( 3 << TIMING_CFG1_WRREC_SHIFT) | \
+ (10 << TIMING_CFG1_REFREC_SHIFT) | \
+ ( 3 << TIMING_CFG1_ACTTORW_SHIFT) | \
+ ( 8 << TIMING_CFG1_ACTTOPRE_SHIFT) | \
+ ( 3 << TIMING_CFG1_PRETOACT_SHIFT))
+
+#define CFG_DDR_TIMING_2 ((9 << TIMING_CFG2_FOUR_ACT_SHIFT) | \
+ (4 << TIMING_CFG2_CKE_PLS_SHIFT) | \
+ (2 << TIMING_CFG2_WR_DATA_DELAY_SHIFT) | \
+ (2 << TIMING_CFG2_RD_TO_PRE_SHIFT) | \
+ (2 << TIMING_CFG2_WR_LAT_DELAY_SHIFT) | \
+ (0 << TIMING_CFG2_ADD_LAT_SHIFT) | \
+ (0 << TIMING_CFG2_CPO_SHIFT))
+
+#define CFG_DDR_TIMING_3 0x00000000
/*
* Memory test
* NAND flash on the local bus
*/
#define CFG_NAND_BASE 0x60000000
+#define CONFIG_CMD_NAND 1
+#define CONFIG_NAND_FSL_UPM 1
+#define CFG_MAX_NAND_DEVICE 1
+#define NAND_MAX_CHIPS 1
+#define CONFIG_MTD_NAND_VERIFY_WRITE
#define CFG_LBLAWBAR1_PRELIM CFG_NAND_BASE
#define CFG_LBLAWAR1_PRELIM 0x8000001b /* Access window size 4K */
* QE UEC ethernet configuration
*/
#define CONFIG_UEC_ETH
-#define CONFIG_ETHPRIME "Freescale GETH"
+#define CONFIG_ETHPRIME "FSL UEC0"
#define CONFIG_UEC_ETH1 /* GETH1 */
#define CFG_UEC1_TX_CLK QE_CLK9
#define CFG_UEC1_ETH_TYPE GIGA_ETH
#define CFG_UEC1_PHY_ADDR 2
-#define CFG_UEC1_INTERFACE_MODE ENET_1000_GMII
+#define CFG_UEC1_INTERFACE_MODE ENET_1000_RGMII_RXID
#endif
#define CONFIG_UEC_ETH2 /* GETH2 */
#define CFG_UEC2_TX_CLK QE_CLK4
#define CFG_UEC2_ETH_TYPE GIGA_ETH
#define CFG_UEC2_PHY_ADDR 4
-#define CFG_UEC2_INTERFACE_MODE ENET_1000_GMII
+#define CFG_UEC2_INTERFACE_MODE ENET_1000_RGMII_RXID
#endif
/*
#define CONFIG_CMD_PING
#define CONFIG_CMD_I2C
#define CONFIG_CMD_ASKENV
+#define CONFIG_CMD_DHCP
#if defined(CONFIG_PCI)
#define CONFIG_CMD_PCI
#define CFG_HID0_FINAL HID0_ENABLE_MACHINE_CHECK
#define CFG_HID2 HID2_HBE
-/*
- * Cache Config
- */
-#define CFG_DCACHE_SIZE 32768
-#define CFG_CACHELINE_SIZE 32
-#if defined(CONFIG_CMD_KGDB)
-#define CFG_CACHELINE_SHIFT 5 /*log base 2 of the above value */
-#endif
-
/*
* MMU Setup
*/
"consoledev=ttyS0\0"\
"loadaddr=a00000\0"\
"fdtaddr=900000\0"\
- "bootfile=uImage\0"\
"fdtfile=dtb\0"\
"fsfile=fs\0"\
"ubootfile=u-boot.bin\0"\
+ "mtdparts=mtdparts=60000000.nand-flash:4096k(kernel),128k(dtb),-(rootfs)\0"\
"setbootargs=setenv bootargs console=$consoledev,$baudrate "\
"$mtdparts panic=1\0"\
"adddhcpargs=setenv bootargs $bootargs ip=on\0"\
"addnfsargs=setenv bootargs $bootargs ip=$ipaddr:$serverip:"\
"$gatewayip:$netmask:$hostname:$netdev:off "\
"root=/dev/nfs rw nfsroot=$serverip:$rootpath\0"\
+ "addnandargs=setenv bootargs $bootargs root=/dev/mtdblock3 "\
+ "rootfstype=jffs2 rw\0"\
"tftp_get_uboot=tftp 100000 $ubootfile\0"\
"tftp_get_kernel=tftp $loadaddr $bootfile\0"\
"tftp_get_dtb=tftp $fdtaddr $fdtfile\0"\
"tftp_get_fs=tftp c00000 $fsfile\0"\
+ "nand_erase_kernel=nand erase 0 400000\0"\
+ "nand_erase_dtb=nand erase 400000 20000\0"\
+ "nand_erase_fs=nand erase 420000 3be0000\0"\
+ "nand_write_kernel=nand write.jffs2 $loadaddr 0 400000\0"\
+ "nand_write_dtb=nand write.jffs2 $fdtaddr 400000 20000\0"\
+ "nand_write_fs=nand write.jffs2 c00000 420000 $filesize\0"\
+ "nand_read_kernel=nand read.jffs2 $loadaddr 0 400000\0"\
+ "nand_read_dtb=nand read.jffs2 $fdtaddr 400000 20000\0"\
"nor_reflash=protect off ff800000 ff87ffff ; erase ff800000 ff87ffff ; "\
"cp.b 100000 ff800000 $filesize\0"\
+ "nand_reflash_kernel=run tftp_get_kernel nand_erase_kernel "\
+ "nand_write_kernel\0"\
+ "nand_reflash_dtb=run tftp_get_dtb nand_erase_dtb nand_write_dtb\0"\
+ "nand_reflash_fs=run tftp_get_fs nand_erase_fs nand_write_fs\0"\
+ "nand_reflash=run nand_reflash_kernel nand_reflash_dtb "\
+ "nand_reflash_fs\0"\
"boot_m=bootm $loadaddr - $fdtaddr\0"\
- "dhcpboot=run setbootargs adddhcpargs tftp_get_kernel tftp_get_dtb "\
- "boot_m\0"\
+ "dhcpboot=dhcp ; run setbootargs adddhcpargs tftp_get_dtb boot_m\0"\
"nfsboot=run setbootargs addnfsargs tftp_get_kernel tftp_get_dtb "\
- "boot_m\0"\
+ "boot_m\0"\
+ "nandboot=run setbootargs addnandargs nand_read_kernel nand_read_dtb "\
+ "boot_m\0"\
""
#define CONFIG_BOOTCOMMAND "run dhcpboot"
projects / u-boot / blobdiff