ls102xa: Adjust some macros for SD boot on LS1021A QDS board

[u-boot] / include / configs / P2041RDB.h

diff --git a/include/configs/P2041RDB.h b/include/configs/P2041RDB.h
index d8d30bb2805d3f949e3c261d2d3b875b6a5a5523..2c4c8b5a026991125077c1787c5c0bf68d2cb17a 100644 (file)
--- a/include/configs/P2041RDB.h
+++ b/include/configs/P2041RDB.h
@@ -13,7 +13,6 @@
 
 #define CONFIG_P2041RDB
 #define CONFIG_PHYS_64BIT
-#define CONFIG_SYS_GENERIC_BOARD
 #define CONFIG_DISPLAY_BOARDINFO
 #define CONFIG_PPC_P2041
 
@@ -251,7 +250,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 
 #define CONFIG_SYS_NAND_BASE_LIST     {CONFIG_SYS_NAND_BASE}
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_MTD_NAND_VERIFY_WRITE
 #define CONFIG_CMD_NAND
 #define CONFIG_SYS_NAND_BLOCK_SIZE    (128 * 1024)
 
@@ -413,7 +411,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
  * eSPI - Enhanced SPI
  */
 #define CONFIG_FSL_ESPI
-#define CONFIG_SPI_FLASH
 #define CONFIG_SPI_FLASH_SPANSION
 #define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED         10000000
@@ -564,7 +561,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 #ifdef CONFIG_PCI
 #define CONFIG_PCI_INDIRECT_BRIDGE
 #define CONFIG_PCI_PNP                 /* do pci plug-and-play */
-#define CONFIG_E1000
 
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup */
 #define CONFIG_DOS_PARTITION
@@ -620,21 +616,16 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_GREPENV
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_PING
-#define CONFIG_CMD_SETEXPR
 
 #ifdef CONFIG_PCI
 #define CONFIG_CMD_PCI
-#define CONFIG_CMD_NET
 #endif
 
 /*