usb: dwc3: Add DWC3 controller driver support

[u-boot] / include / configs / T104xRDB.h

diff --git a/include/configs/T104xRDB.h b/include/configs/T104xRDB.h
index a54e0ebca27fce4fe8624283013d10d58acfb2d7..16d2e0e1c7d69328c7723850c182aa2e794e5e7d 100644 (file)
--- a/include/configs/T104xRDB.h
+++ b/include/configs/T104xRDB.h
@@ -104,7 +104,10 @@
 
 /* support deep sleep */
 #define CONFIG_DEEP_SLEEP
+#if defined(CONFIG_DEEP_SLEEP)
+#define CONFIG_BOARD_EARLY_INIT_F
 #define CONFIG_SILENT_CONSOLE
+#endif
 
 #ifndef CONFIG_SYS_TEXT_BASE
 #define CONFIG_SYS_TEXT_BASE   0xeff40000
@@ -217,7 +220,6 @@
 #define CONFIG_CHIP_SELECTS_PER_CTRL   (2 * CONFIG_DIMM_SLOTS_PER_CTLR)
 
 #define CONFIG_DDR_SPD
-#define CONFIG_SYS_DDR_RAW_TIMING
 #define CONFIG_SYS_FSL_DDR3
 
 #define CONFIG_SYS_SPD_BUS_NUM 0
@@ -339,7 +341,6 @@
 #define CONFIG_SYS_NAND_DDR_LAW                11
 #define CONFIG_SYS_NAND_BASE_LIST      { CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_MTD_NAND_VERIFY_WRITE
 #define CONFIG_CMD_NAND
 
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (512 * 1024)
@@ -515,7 +516,6 @@
  * eSPI - Enhanced SPI
  */
 #define CONFIG_FSL_ESPI
-#define CONFIG_SPI_FLASH
 #define CONFIG_SPI_FLASH_STMICRO
 #define CONFIG_SPI_FLASH_BAR
 #define CONFIG_CMD_SF
@@ -723,6 +723,14 @@
 #define CONFIG_SYS_RGMII1_PHY_ADDR             0x01
 #define CONFIG_SYS_RGMII2_PHY_ADDR             0x02
 
+/* Enable VSC9953 L2 Switch driver on T1040 SoC */
+#ifdef CONFIG_T1040RDB
+#define CONFIG_VSC9953
+#define CONFIG_VSC9953_CMD
+#define CONFIG_SYS_FM1_QSGMII11_PHY_ADDR       0x04
+#define CONFIG_SYS_FM1_QSGMII21_PHY_ADDR       0x08
+#endif
+
 #define CONFIG_MII             /* MII PHY management */
 #define CONFIG_ETHPRIME                "FM1@DTSEC4"
 #define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
@@ -737,8 +745,6 @@
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #ifdef CONFIG_T1042RDB_PI
 #define CONFIG_CMD_DATE
 #endif
@@ -751,11 +757,9 @@
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_REGINFO
-#define CONFIG_CMD_SETEXPR
 
 #ifdef CONFIG_PCI
 #define CONFIG_CMD_PCI
-#define CONFIG_CMD_NET
 #endif
 
 /* Hash command with SHA acceleration supported in hardware */