ls102xa: Adjust some macros for SD boot on LS1021A QDS board

[u-boot] / include / configs / T208xQDS.h

diff --git a/include/configs/T208xQDS.h b/include/configs/T208xQDS.h
index b0ee0de1361741321348b8cffa2842e0ca8f5d2b..a81f1e66f3fc95ff2bf1b53fcf413126824b9688 100644 (file)
--- a/include/configs/T208xQDS.h
+++ b/include/configs/T208xQDS.h
@@ -11,7 +11,6 @@
 #ifndef __T208xQDS_H
 #define __T208xQDS_H
 
-#define CONFIG_SYS_GENERIC_BOARD
 #define CONFIG_DISPLAY_BOARDINFO
 #define CONFIG_ICS307_REFCLK_HZ 25000000  /* ICS307 ref clk freq */
 #define CONFIG_MMC
@@ -430,7 +429,7 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR       0xfdd00000 /* Initial L1 address */
 #define CONFIG_SYS_INIT_RAM_ADDR_PHYS_HIGH     0xf
-#define CONFIG_SYS_INIT_RAM_ADDR_PHYS_LOW      0xfe0ec000
+#define CONFIG_SYS_INIT_RAM_ADDR_PHYS_LOW      0xfe03c000
 /* The assembler doesn't like typecast */
 #define CONFIG_SYS_INIT_RAM_ADDR_PHYS \
                        ((CONFIG_SYS_INIT_RAM_ADDR_PHYS_HIGH * 1ull << 32) | \
@@ -619,7 +618,6 @@ unsigned long get_board_ddr_clk(void);
 #ifdef CONFIG_PCI
 #define CONFIG_PCI_INDIRECT_BRIDGE
 #define CONFIG_FSL_PCIE_RESET     /* need PCIe reset errata */
-#define CONFIG_E1000
 #define CONFIG_PCI_PNP         /* do pci plug-and-play */
 #define CONFIG_PCI_SCAN_SHOW   /* show pci devices on startup */
 #define CONFIG_DOS_PARTITION
@@ -793,7 +791,6 @@ unsigned long get_board_ddr_clk(void);
  * Command line configuration.
  */
 #define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_GREPENV
 #define CONFIG_CMD_IRQ