Convert CONFIG_APBH_DMA et al to Kconfig

[u-boot] / include / configs / colibri_imx7.h

diff --git a/include/configs/colibri_imx7.h b/include/configs/colibri_imx7.h
index 30a2d1286b838c82679234b87f21751938be7181..5d9b2126323b64a5b55c3ab793c79a0693062c90 100644 (file)
--- a/include/configs/colibri_imx7.h
+++ b/include/configs/colibri_imx7.h
@@ -105,7 +105,7 @@
        "m4boot=;\0" \
        "ip_dyn=yes\0" \
        "kernel_file=zImage\0" \
-       "mtdparts=" MTDPARTS_DEFAULT "\0" \
+       "mtdparts=" CONFIG_MTDPARTS_DEFAULT "\0" \
        "setethupdate=if env exists ethaddr; then; else setenv ethaddr " \
                "00:14:2d:00:00:00; fi; tftpboot ${loadaddr} " \
                "${board}/flash_eth.img && source ${loadaddr}\0" \
@@ -158,8 +158,6 @@
 #define CONFIG_ENV_SIZE                        CONFIG_ENV_SECT_SIZE
 #endif
 
-#define CONFIG_NAND_MXS
-
 /* NAND stuff */
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
 #define CONFIG_SYS_NAND_BASE           0x40000000
@@ -170,18 +168,8 @@
 /* Dynamic MTD partition support */
 #define CONFIG_MTD_PARTITIONS
 #define CONFIG_MTD_DEVICE      /* needed for mtdparts commands */
-#define MTDIDS_DEFAULT         "nand0=gpmi-nand"
-#define MTDPARTS_DEFAULT       "mtdparts=gpmi-nand:"           \
-                               "512k(mx7-bcb),"                \
-                               "1536k(u-boot1)ro,"             \
-                               "1536k(u-boot2)ro,"             \
-                               "512k(u-boot-env),"             \
-                               "-(ubi)"
 
 /* DMA stuff, needed for GPMI/MXS NAND support */
-#define CONFIG_APBH_DMA
-#define CONFIG_APBH_DMA_BURST
-#define CONFIG_APBH_DMA_BURST8
 
 /* USB Configs */
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
@@ -194,8 +182,6 @@
 
 #define CONFIG_USBD_HS
 
-#define CONFIG_USB_FUNCTION_MASS_STORAGE
-
 /* USB Device Firmware Update support */
 #define CONFIG_SYS_DFU_DATA_BUF_SIZE   SZ_16M
 #define DFU_DEFAULT_POLL_TIMEOUT       300