ls102xa: Adjust some macros for SD boot on LS1021A QDS board

[u-boot] / include / configs / colibri_t20.h

diff --git a/include/configs/colibri_t20.h b/include/configs/colibri_t20.h
index d0585f6a01552e7c8ba04e6406c87df009631799..7611fc5004cc890f6cd2b0b4f8a9c797ca84560b 100644 (file)
--- a/include/configs/colibri_t20.h
+++ b/include/configs/colibri_t20.h
@@ -1,6 +1,8 @@
 /*
  * Copyright (C) 2012 Lucas Stach
  *
+ * Configuration settings for the Toradex Colibri T20 modules.
+ *
  * SPDX-License-Identifier:    GPL-2.0+
  */
 
@@ -36,7 +38,7 @@
 #define CONFIG_USB_EHCI_TEGRA
 #define CONFIG_USB_ULPI
 #define CONFIG_USB_ULPI_VIEWPORT
-#define CONFIG_USB_MAX_CONTROLLER_COUNT 3
+#define CONFIG_USB_MAX_CONTROLLER_COUNT        3
 #define CONFIG_USB_STORAGE
 #define CONFIG_CMD_USB
 
@@ -46,6 +48,9 @@
 
 /* General networking support */
 #define CONFIG_CMD_DHCP
+#define CONFIG_IP_DEFRAG
+#define CONFIG_TFTP_BLOCKSIZE          1536
+#define CONFIG_TFTP_TSIZE
 
 /* LCD support */
 #define CONFIG_LCD
@@ -60,7 +65,7 @@
 /* NAND support */
 #define CONFIG_CMD_NAND
 #define CONFIG_TEGRA_NAND
-#define CONFIG_SYS_MAX_NAND_DEVICE     1
+#define CONFIG_SYS_MAX_NAND_DEVICE     1
 
 /* Dynamic MTD partition support */
 #define CONFIG_CMD_MTDPARTS    /* Enable 'mtdparts' command line support */
@@ -75,9 +80,17 @@
 
 /* Environment in NAND, 64K is a bit excessive but erase block is 512K anyway */
 #define CONFIG_ENV_IS_IN_NAND
-#define CONFIG_ENV_OFFSET              (SZ_2M)
-#undef  CONFIG_ENV_SIZE /* undef size from tegra20-common.h */
-#define CONFIG_ENV_SIZE                (SZ_64K)
+#define CONFIG_ENV_OFFSET              (SZ_2M)
+#undef CONFIG_ENV_SIZE         /* undef size from tegra20-common.h */
+#define CONFIG_ENV_SIZE                        (SZ_64K)
+
+/* UBI */
+#define CONFIG_CMD_BOOTZ
+#define CONFIG_CMD_UBI
+#define CONFIG_CMD_UBIFS       /* increases size by almost 60 KB */
+#define CONFIG_LZO
+#define CONFIG_MTD_UBI_FASTMAP
+#define CONFIG_RBTREE
 
 /* Debug commands */
 #define CONFIG_CMD_CACHE