* - GPIO16 is Power LED control (0 = on, 1 = off)
* - GPIO17 is Power LED source select (0 = CPLD, 1 = GPIO16)
* - GPIO18 is Power Button status (0 = Released, 1 = Pressed)
- * - Last GPIO is 26, further bits are supposed to be 0.
+ * - GPIO19 is SATA disk power toggle (toggles on 0-to-1)
+ * - GPIO22 is SATA disk power status ()
+ * - GPIO23 is supply status for SATA disk ()
+ * - GPIO24 is supply control for board (write 1 to power off)
+ * Last GPIO is 25, further bits are supposed to be 0.
* Enable mask has ones for INPUT, 0 for OUTPUT.
- * Default is LED ON.
+ * Default is LED ON, board ON :)
*/
-#define ORION5X_GPIO_OUT_ENABLE 0x03fcffff
-#define ORION5X_GPIO_OUT_VALUE 0x03fcffff
+#define ORION5X_GPIO_OUT_ENABLE 0xfef4f0ca
+#define ORION5X_GPIO_OUT_VALUE 0x00000000
+#define ORION5X_GPIO_IN_POLARITY 0x000000d0
/*
* NS16550 Configuration
#include <config_cmd_default.h>
#define CONFIG_CMD_IDE
#define CONFIG_CMD_I2C
+#define CONFIG_CMD_USB
/*
* Network
/* end of IDE defines */
#endif /* CMD_IDE */
+/*
+ * Common USB/EHCI configuration
+ */
+#ifdef CONFIG_CMD_USB
+#define CONFIG_USB_EHCI /* Enable EHCI USB support */
+#define CONFIG_USB_EHCI_MARVELL
+#define ORION5X_USB20_HOST_PORT_BASE ORION5X_USB20_PORT0_BASE
+#define CONFIG_USB_STORAGE
+#define CONFIG_DOS_PARTITION
+#define CONFIG_ISO_PARTITION
+#define CONFIG_SUPPORT_VFAT
+#endif /* CONFIG_CMD_USB */
+
/*
* I2C related stuff
*/
/*
* Size of malloc() pool
*/
-#define CONFIG_SYS_MALLOC_LEN (1024 * 128) /* 128kB for malloc() */
+#define CONFIG_SYS_MALLOC_LEN (1024 * 256) /* 256kB for malloc() */
/*
* Other required minimal configurations
#define CONFIG_DISPLAY_CPUINFO /* Display cpu info */
#define CONFIG_NR_DRAM_BANKS 1
-#define CONFIG_STACKSIZE 0x00100000
#define CONFIG_SYS_LOAD_ADDR 0x00800000
#define CONFIG_SYS_MEMTEST_START 0x00400000
#define CONFIG_SYS_MEMTEST_END 0x007fffff
/* Use the HUSH parser */
#define CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
/* Enable command line editing */
#define CONFIG_CMDLINE_EDITING