Armada100: Add SPI flash support for Marvell gplugD

[u-boot] / include / configs / ep8260.h

diff --git a/include/configs/ep8260.h b/include/configs/ep8260.h
index ab646ae348b7d6972e1a1bd08b2a05200aa69394..f19360d501220cb79bf6c1d11141eae2c86bf5ec 100644 (file)
--- a/include/configs/ep8260.h
+++ b/include/configs/ep8260.h
@@ -200,8 +200,8 @@
  * - RAM for BD/Buffers is on the local Bus (see 28-13)
  * - Enable Half Duplex in FSMR
  */
-# define CONFIG_SYS_CMXFCR_MASK        (CMXFCR_FC3|CMXFCR_RF3CS_MSK|CMXFCR_TF3CS_MSK)
-# define CONFIG_SYS_CMXFCR_VALUE       (CMXFCR_RF3CS_CLK15|CMXFCR_TF3CS_CLK16)
+# define CONFIG_SYS_CMXFCR_MASK3       (CMXFCR_FC3|CMXFCR_RF3CS_MSK|CMXFCR_TF3CS_MSK)
+# define CONFIG_SYS_CMXFCR_VALUE3      (CMXFCR_RF3CS_CLK15|CMXFCR_TF3CS_CLK16)
 
 /*
  * - RAM for BD/Buffers is on the local Bus (see 28-13)
@@ -429,9 +429,8 @@
  * Definitions for initial stack pointer and data area (in DPRAM)
  */
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_IMMR
-#define CONFIG_SYS_INIT_RAM_END        0x4000  /* End of used area in DPRAM    */
-#define CONFIG_SYS_GBL_DATA_SIZE      128     /* bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET    (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE        0x4000  /* Size of used area in DPRAM    */
+#define CONFIG_SYS_GBL_DATA_OFFSET    (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
 /*-----------------------------------------------------------------------
@@ -747,14 +746,6 @@
                           ORxG_SCY_10_CLK)
 #endif
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD   0x01    /* Normal Power-On: Boot from FLASH  */
-#define BOOTFLAG_WARM   0x02    /* Software reboot                   */
-
 /*
  * JFFS2 partitions
  *