#define CONFIG_EBIU_AMBCTL0_VAL 0xffc2ffc2
#define CONFIG_EBIU_AMBCTL1_VAL 0xffc2ffc2
-#define CONFIG_SYS_MONITOR_LEN (256 * 1024)
+#define CONFIG_SYS_MONITOR_LEN (384 * 1024)
#define CONFIG_SYS_MALLOC_LEN (128 * 1024)
* Network Settings
*/
#define ADI_CMDS_NETWORK 1
-#define CONFIG_NET_MULTI 1
#define CONFIG_HOSTNAME IP04
#define CONFIG_DRIVER_DM9000 1
#define CONFIG_BFIN_SPI
#define CONFIG_ENV_SPI_MAX_HZ 30000000
#define CONFIG_SF_DEFAULT_SPEED 30000000
-#define CONFIG_SPI_FLASH
#define CONFIG_SPI_FLASH_STMICRO
#define CONFIG_SPI_FLASH_WINBOND
#define BFIN_NAND_CLE(chip) ((unsigned long)(chip)->IO_ADDR_W | (1 << 2))
#define BFIN_NAND_ALE(chip) ((unsigned long)(chip)->IO_ADDR_W | (1 << 1))
-#define BFIN_NAND_READY PF10
#define BFIN_NAND_WRITE(addr, cmd) \
do { \
bfin_write8(addr, cmd); \
#define NAND_PLAT_WRITE_CMD(chip, cmd) BFIN_NAND_WRITE(BFIN_NAND_CLE(chip), cmd)
#define NAND_PLAT_WRITE_ADR(chip, cmd) BFIN_NAND_WRITE(BFIN_NAND_ALE(chip), cmd)
-#define NAND_PLAT_DEV_READY(chip) (bfin_read_FIO_FLAG_D() & BFIN_NAND_READY)
-#define NAND_PLAT_INIT() \
- do { \
- bfin_write_FIO_DIR(bfin_read_FIO_DIR() & ~BFIN_NAND_READY); \
- bfin_write_FIO_INEN(bfin_read_FIO_INEN() | BFIN_NAND_READY); \
- bfin_write_FIO_EDGE(bfin_read_FIO_EDGE() & ~BFIN_NAND_READY); \
- bfin_write_FIO_POLAR(bfin_read_FIO_POLAR() & ~BFIN_NAND_READY); \
- } while (0)
+#define NAND_PLAT_GPIO_DEV_READY GPIO_PF10
/*
* Misc Settings
*/
#define CONFIG_BAUDRATE 115200
-#define CONFIG_MISC_INIT_R /* needed for MAC address */
#define CONFIG_UART_CONSOLE 0
#undef CONFIG_SHOW_BOOT_PROGRESS
/* Enable this if bootretry required; currently it's disabled */
#define CONFIG_BOOT_RETRY_TIME -1
#define CONFIG_BOOTCOMMAND "run nandboot"
-#define CONFIG_AUTOBOOT_PROMPT "autoboot in %d seconds\n"
/*