#define CONFIG_SYS_FLASH_BASE 0xFC000000
#define CONFIG_SYS_NAND_ADDR 0xF8000000
#define CONFIG_SYS_FPGA_BASE 0xF0000000
-#define CONFIG_SYS_PERIPHERAL_BASE 0xEF600000 /* internal peripherals*/
/*-----------------------------------------------------------------------
* Initial RAM & Stack Pointer Configuration Options
#if defined(CONFIG_SYS_INIT_DCACHE_CS)
# define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET
-# define CONFIG_SYS_POST_ALT_WORD_ADDR (CONFIG_SYS_PERIPHERAL_BASE + GPT0_COMP6)
+# define CONFIG_SYS_POST_WORD_ADDR (CONFIG_SYS_PERIPHERAL_BASE + GPT0_COMP6)
#else
# define CONFIG_SYS_INIT_EXTRA_SIZE 16
# define CONFIG_SYS_INIT_SP_OFFSET (CONFIG_SYS_GBL_DATA_OFFSET - CONFIG_SYS_INIT_EXTRA_SIZE)
-# define CONFIG_SYS_POST_WORD_ADDR (CONFIG_SYS_GBL_DATA_OFFSET - 4)
# define CONFIG_SYS_OCM_DATA_ADDR CONFIG_SYS_INIT_RAM_ADDR
#endif /* defined(CONFIG_SYS_INIT_DCACHE_CS) */
* Serial Port
*----------------------------------------------------------------------*/
#define CONFIG_SYS_EXT_SERIAL_CLOCK 11059200 /* ext. 11.059MHz clk */
-/* define this if you want console on UART1 */
-#undef CONFIG_UART1_CONSOLE
+#define CONFIG_CONS_INDEX 1 /* Use UART0 */
/*-----------------------------------------------------------------------
* Environment
* SDRAM Controller DDR autocalibration values and takes a lot longer
* to run than Method_B.
* (See the Method_A and Method_B algorithm discription in the file:
- * arch/ppc/cpu/ppc4xx/4xx_ibm_ddr2_autocalib.c)
+ * arch/powerpc/cpu/ppc4xx/4xx_ibm_ddr2_autocalib.c)
* Define CONFIG_PPC4xx_DDR_METHOD_A to use DDR autocalibration Method_A
*
* DDR Autocalibration Method_B is the default.