powerpc: ppc4xx: remove redundant CONFIG_4xx definition

[u-boot] / include / configs / korat.h

diff --git a/include/configs/korat.h b/include/configs/korat.h
index 3410733ed72907ca689c1812b501233df0b621cb..5494a6007dfb32c8903b388520d4a4d3456ade11 100644 (file)
--- a/include/configs/korat.h
+++ b/include/configs/korat.h
@@ -22,7 +22,6 @@
  * High Level Configuration Options
  */
 #define CONFIG_440EPX          1       /* Specific PPC440EPx           */
-#define CONFIG_4xx             1       /* ... PPC4xx family            */
 #define CONFIG_SYS_CLK_FREQ    33333333
 
 #ifdef CONFIG_KORAT_PERMANENT
@@ -142,11 +141,11 @@
 /*
  * I2C
  */
-#define CONFIG_HARD_I2C                1       /* I2C with hardware support    */
-#undef CONFIG_SOFT_I2C                 /* I2C bit-banged               */
-#define CONFIG_PPC4XX_I2C              /* use PPC4xx driver            */
-#define CONFIG_SYS_I2C_SPEED           400000  /* I2C speed and slave address  */
-#define CONFIG_SYS_I2C_SLAVE           0x7F
+#define CONFIG_SYS_I2C
+#define CONFIG_SYS_I2C_PPC4XX
+#define CONFIG_SYS_I2C_PPC4XX_CH0
+#define CONFIG_SYS_I2C_PPC4XX_SPEED_0          400000
+#define CONFIG_SYS_I2C_PPC4XX_SLAVE_0          0x7F
 
 #define CONFIG_SYS_I2C_MULTI_EEPROMS
 #define CONFIG_SYS_I2C_EEPROM_ADDR     (0xa8>>1)
@@ -307,7 +306,6 @@
  * Miscellaneous configurable options
  */
 #define CONFIG_SYS_LONGHELP                    /* undef to save memory         */
-#define CONFIG_SYS_PROMPT              "=> "   /* Monitor Command Prompt       */
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_SYS_CBSIZE              1024    /* Console I/O Buffer Size      */
 #else
@@ -324,8 +322,6 @@
 #define CONFIG_SYS_LOAD_ADDR           0x100000  /* default load address       */
 #define CONFIG_SYS_EXTBDINFO           1  /* To use extended board_into (bd_t) */
 
-#define CONFIG_SYS_HZ                  1000    /* decrementer freq: 1 ms ticks */
-
 #define CONFIG_CMDLINE_EDITING 1       /* add command line history     */
 #define CONFIG_LOOPW           1       /* enable loopw command         */
 #define CONFIG_MX_CYCLIC       1       /* enable mdc/mwc commands      */
@@ -545,7 +541,6 @@
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400 /* speed to run kgdb serial port */
-#define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use     */
 #endif
 
 /* Pass open firmware flat tree */