Add support for KVME080 board

[u-boot] / include / configs / ocotea.h

diff --git a/include/configs/ocotea.h b/include/configs/ocotea.h
index 4f90b1b51d91b27a03528b2fb343d4a1508a3cd8..a13d6a870abc921a87ffdbfce889e5a21d6dc758 100644 (file)
--- a/include/configs/ocotea.h
+++ b/include/configs/ocotea.h
@@ -30,7 +30,7 @@
 
 
 /************************************************************************
- * OCOTEA.h - configuration for IBM 440GX Ref (Ocotea)
+ * OCOTEA.h - configuration for AMCC 440GX Ref (Ocotea)
  ***********************************************************************/
 
 #ifndef __CONFIG_H
@@ -40,7 +40,7 @@
  * High Level Configuration Options
  *----------------------------------------------------------------------*/
 #define CONFIG_OCOTEA          1           /* Board is ebony           */
-#define CONFIG_440_GX          1           /* Specifc GX support       */
+#define CONFIG_440GX           1           /* Specifc GX support       */
 #define CONFIG_4xx             1           /* ... PPC4xx family        */
 #define CONFIG_BOARD_EARLY_INIT_F 1        /* Call board_pre_init      */
 #undef CFG_DRAM_TEST                       /* Disable-takes long time! */
@@ -170,17 +170,17 @@
        "netdev=eth0\0"                                                 \
        "hostname=ocotea\0"                                             \
        "nfsargs=setenv bootargs root=/dev/nfs rw "                     \
-               "nfsroot=$(serverip):$(rootpath)\0"                     \
+               "nfsroot=${serverip}:${rootpath}\0"                     \
        "ramargs=setenv bootargs root=/dev/ram rw\0"                    \
-       "addip=setenv bootargs $(bootargs) "                            \
-               "ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask)"      \
-               ":$(hostname):$(netdev):off panic=1\0"                  \
-       "addtty=setenv bootargs $(bootargs) console=ttyS0,$(baudrate)\0"\
+       "addip=setenv bootargs ${bootargs} "                            \
+               "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}"      \
+               ":${hostname}:${netdev}:off panic=1\0"                  \
+       "addtty=setenv bootargs ${bootargs} console=ttyS0,${baudrate}\0"\
        "flash_nfs=run nfsargs addip addtty;"                           \
-               "bootm $(kernel_addr)\0"                                \
+               "bootm ${kernel_addr}\0"                                \
        "flash_self=run ramargs addip addtty;"                          \
-               "bootm $(kernel_addr) $(ramdisk_addr)\0"                \
-       "net_nfs=tftp 200000 $(bootfile);run nfsargs addip addtty;"     \
+               "bootm ${kernel_addr} ${ramdisk_addr}\0"                \
+       "net_nfs=tftp 200000 ${bootfile};run nfsargs addip addtty;"     \
                "bootm\0"                                               \
        "rootpath=/opt/eldk/ppc_4xx\0"                                  \
        "bootfile=/tftpboot/ocotea/uImage\0"                            \
@@ -211,8 +211,14 @@
 #define CONFIG_PHY1_ADDR       2
 #define CONFIG_PHY2_ADDR       0x10
 #define CONFIG_PHY3_ADDR       0x18
+#define CONFIG_HAS_ETH0
+#define CONFIG_HAS_ETH1
+#define CONFIG_HAS_ETH2
+#define CONFIG_HAS_ETH3
 #define CONFIG_CIS8201_PHY     1       /* Enable 'special' RGMII mode for Cicada phy */
 #define CONFIG_PHY_GIGE                1       /* Include GbE speed/duplex detection */
+#define CONFIG_PHY_RESET        1       /* reset phy upon startup         */
+#define CONFIG_PHY_RESET_DELAY 1000
 
 #define CONFIG_COMMANDS               (CONFIG_CMD_DFL  | \
                                CFG_CMD_ASKENV  | \
@@ -256,14 +262,16 @@
 #define CFG_LOAD_ADDR          0x100000        /* default load address */
 #define CFG_EXTBDINFO          1       /* To use extended board_into (bd_t) */
 
-#define CFG_HZ         100             /* decrementer freq: 1 ms ticks */
+#define CFG_HZ                 1000    /* decrementer freq: 1 ms ticks */
 
 #define CONFIG_AUTO_COMPLETE   1       /* add autocompletion support   */
 #define CONFIG_LOOPW            1       /* enable loopw command         */
 #define CONFIG_ZERO_BOOTDELAY_CHECK    /* check for keypress on bootdelay==0 */
 #define CONFIG_VERSION_VARIABLE 1      /* include version env variable */
 
-#define CFG_RX_ETH_BUFFER      32        /* Number of ethernet rx buffers & descriptors */
+#define CFG_RX_ETH_BUFFER      32      /* Number of ethernet rx buffers & descriptors */
+
+#define CONFIG_NETCONSOLE              /* include NetConsole support   */
 
 /*-----------------------------------------------------------------------
  * PCI stuff
@@ -291,7 +299,7 @@
 /*-----------------------------------------------------------------------
  * Cache Configuration
  */
-#define CFG_DCACHE_SIZE                32768   /* For IBM 440 CPUs                     */
+#define CFG_DCACHE_SIZE                32768   /* For AMCC 440 CPUs                    */
 #define CFG_CACHELINE_SIZE     32      /* ...                  */
 #if (CONFIG_COMMANDS & CFG_CMD_KGDB)
 #define CFG_CACHELINE_SHIFT    5       /* log base 2 of the above value        */