mpc8313erdb: Enable NAND in config.

[u-boot] / include / configs / pf5200.h

diff --git a/include/configs/pf5200.h b/include/configs/pf5200.h
index 3e72c652bc7979310006b6476c8c8f2bee3b66fc..c065d3328c97be28156e6d2e38ef6e9114a03cde 100644 (file)
--- a/include/configs/pf5200.h
+++ b/include/configs/pf5200.h
@@ -49,6 +49,7 @@
 #define BOOTFLAG_COLD          0x01    /* Normal Power-On: Boot from FLASH  */
 #define BOOTFLAG_WARM          0x02    /* Software reboot           */
 
+#define CONFIG_HIGH_BATS       1       /* High BATs supported */
 /*
  * Serial console configuration
  */
@@ -69,6 +70,7 @@
 #define CONFIG_PCI             1
 #define CONFIG_PCI_PNP         1
 #define CONFIG_PCI_SCAN_SHOW   1
+#define CONFIG_PCIAUTO_SKIP_HOST_BRIDGE        1
 
 #define CONFIG_PCI_MEM_BUS     0x40000000
 #define CONFIG_PCI_MEM_PHYS    CONFIG_PCI_MEM_BUS
@@ -85,13 +87,6 @@
 #define CFG_RX_ETH_BUFFER      8       /* use 8 rx buffer on eepro100  */
 #define CONFIG_NS8382X         1
 #endif
-
-#define ADD_PCI_CMD            CFG_CMD_PCI
-
-#else                          /* MPC5100 */
-
-#define ADD_PCI_CMD            0       /* no CFG_CMD_PCI */
-
 #endif
 
 /* Partitions */
@@ -101,26 +96,35 @@
 /* USB */
 #if 0
 #define CONFIG_USB_OHCI
-#define ADD_USB_CMD            CFG_CMD_USB | CFG_CMD_FAT
 #define CONFIG_USB_STORAGE
-#else
-#define ADD_USB_CMD            0
 #endif
 
 
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
 /*
  * Command line configuration.
  */
 #include <config_cmd_default.h>
 
 #define CONFIG_CMD_BSP
-#define CONFIG_PCI_CMD
 #define CONFIG_CMD_EEPROM
 #define CONFIG_CMD_ELF
 #define CONFIG_CMD_FAT
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_IDE
 
+#ifdef CONFIG_MPC5200
+#define CONFIG_CMD_PCI
+#endif
+
 
 #if (TEXT_BASE == 0xFF000000)  /* Boot low with 16 MB Flash */
 #   define CFG_LOWBOOT         1