power: twl4030: Remove CONFIG_TWL4030_POWER from include/configs

[u-boot] / include / configs / tricorder.h

diff --git a/include/configs/tricorder.h b/include/configs/tricorder.h
index 5e9da85acfd57f333865549415c85785f9b7b347..9741ca5fc992bbec24445593147536109c527a81 100644 (file)
--- a/include/configs/tricorder.h
+++ b/include/configs/tricorder.h
@@ -17,12 +17,7 @@
 #define __CONFIG_H
 
 /* High Level Configuration Options */
-#define CONFIG_SYS_THUMB_BUILD
 #define CONFIG_OMAP                    /* in a TI OMAP core */
-/* Common ARM Erratas */
-#define CONFIG_ARM_ERRATA_454179
-#define CONFIG_ARM_ERRATA_430973
-#define CONFIG_ARM_ERRATA_621766
 
 #define CONFIG_MACH_TYPE               MACH_TYPE_TRICORDER
 /*
@@ -61,18 +56,6 @@
 #define CONFIG_OMAP3_GPIO_2            /* GPIO32..63 are in GPIO bank 2 */
 
 /* LED support */
-#define CONFIG_STATUS_LED
-#define CONFIG_BOARD_SPECIFIC_LED
-#define CONFIG_CMD_LED                 /* LED command */
-#define STATUS_LED_BIT                 (1 << 0)
-#define STATUS_LED_STATE               STATUS_LED_ON
-#define STATUS_LED_PERIOD              (CONFIG_SYS_HZ / 2)
-#define STATUS_LED_BIT1                        (1 << 1)
-#define STATUS_LED_STATE1              STATUS_LED_ON
-#define STATUS_LED_PERIOD1             (CONFIG_SYS_HZ / 2)
-#define STATUS_LED_BIT2                        (1 << 2)
-#define STATUS_LED_STATE2              STATUS_LED_ON
-#define STATUS_LED_PERIOD2             (CONFIG_SYS_HZ / 2)
 
 /* NS16550 Configuration */
 #define CONFIG_SYS_NS16550_SERIAL
@@ -83,14 +66,9 @@
 #define CONFIG_CONS_INDEX              3
 #define CONFIG_SYS_NS16550_COM3                OMAP34XX_UART3
 #define CONFIG_SERIAL3                 3
-#define CONFIG_BAUDRATE                        115200
 #define CONFIG_SYS_BAUDRATE_TABLE      {4800, 9600, 19200, 38400, 57600,\
                                        115200}
 
-/* MMC */
-#define CONFIG_GENERIC_MMC
-#define CONFIG_DOS_PARTITION
-
 /* I2C */
 #define CONFIG_SYS_I2C
 #define CONFIG_SYS_OMAP24_I2C_SPEED    100000
@@ -104,11 +82,9 @@
 #define CONFIG_SYS_EEPROM_BUS_NUM      1
 
 /* TWL4030 */
-#define CONFIG_TWL4030_POWER
 #define CONFIG_TWL4030_LED
 
 /* Board NAND Info */
-#define CONFIG_SYS_NO_FLASH            /* no NOR flash */
 #define CONFIG_MTD_DEVICE              /* needed for mtdparts commands */
 #define MTDIDS_DEFAULT                 "nand0=omap2-nand.0"
 #define MTDPARTS_DEFAULT               "mtdparts=omap2-nand.0:" \