*/
#define CONFIG_PXA27X 1 /* This is an PXA27x CPU */
-#define LITTLEENDIAN 1 /* used by usb_ohci.c */
-
#define CONFIG_MMC 1
#define BOARD_LATE_INIT 1
#undef CONFIG_USE_IRQ /* we don't need IRQ/FIQ stuff */
+/* we will never enable dcache, because we have to setup MMU first */
+#define CONFIG_SYS_NO_DCACHE
+
#define RTC
/*
/*
* select serial console configuration
*/
+#define CONFIG_PXA_SERIAL
#define CONFIG_SERIAL_MULTI
#define CONFIG_FFUART 1 /* we use FFUART on Conxs */
#define CONFIG_BTUART 1 /* we use BTUART on Conxs */
*/
#include <config_cmd_default.h>
-#define CONFIG_CMD_MMC
#define CONFIG_CMD_FAT
#define CONFIG_CMD_IMLS
#define CONFIG_CMD_PING
#define CONFIG_SYS_MEMTEST_START 0xa0400000 /* memtest works on */
#define CONFIG_SYS_MEMTEST_END 0xa0800000 /* 4 ... 8 MB in DRAM */
-#undef CONFIG_SYS_CLKS_IN_HZ /* everything, incl board info, in Hz */
-
#define CONFIG_SYS_LOAD_ADDR 0xa1000000 /* default load address */
-#define CONFIG_SYS_HZ 3686400 /* incrementer freq: 3.6864 MHz */
+#define CONFIG_SYS_HZ 1000
#define CONFIG_SYS_CPUSPEED 0x207 /* need to look more closely, I think this is Turbo = 2x, L=91Mhz */
/* valid baudrates */
#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
+#ifdef CONFIG_MMC
+#define CONFIG_PXA_MMC
+#define CONFIG_CMD_MMC
#define CONFIG_SYS_MMC_BASE 0xF0000000
+#endif
/*
* Stack sizes
#define CONFIG_SYS_MCIO0_VAL 0x00008407
#define CONFIG_SYS_MCIO1_VAL 0x0000c108
+#define CONFIG_NET_MULTI 1
#define CONFIG_DRIVER_DM9000 1
#define CONFIG_DM9000_BASE 0x08000000
#define DM9000_IO CONFIG_DM9000_BASE