usb: dwc3: Add DWC3 controller driver support

[u-boot] / include / configs / x600.h

diff --git a/include/configs/x600.h b/include/configs/x600.h
index 5b6307661473e063a15f80266b6239d2fdb50d64..1d4c1a98269a7e6a78a8842fe305be3cbd031cb8 100644 (file)
--- a/include/configs/x600.h
+++ b/include/configs/x600.h
@@ -74,7 +74,6 @@
 
 /* Ethernet config options */
 #define CONFIG_MII
-#define CONFIG_NET_MULTI
 #define CONFIG_PHYLIB
 #define CONFIG_PHY_RESET_DELAY                 10000           /* in usec */
 #define CONFIG_PHY_ADDR                0       /* PHY address */
@@ -106,24 +105,18 @@
 #define CONFIG_CMD_DATE
 #define CONFIG_CMD_DHCP
 #define CONFIG_CMD_ENV
-#define CONFIG_CMD_FPGA
 #define CONFIG_CMD_FPGA_LOADMK
 #define CONFIG_CMD_GPIO
 #define CONFIG_CMD_I2C
-#define CONFIG_CMD_MEMORY
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_MTDPARTS
 #define CONFIG_CMD_NAND
 #define CONFIG_CMD_PING
-#define CONFIG_CMD_RUN
 #define CONFIG_CMD_SAVES
 #define CONFIG_CMD_UBI
 #define CONFIG_CMD_UBIFS
 #define CONFIG_LZO
 
-/* This must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <config_cmd_default.h>
-
 #define CONFIG_BOOTDELAY                       3
 
 #define CONFIG_SYS_HUSH_PARSER                 /* Use the HUSH parser  */
@@ -152,10 +145,6 @@
 #define CONFIG_LOOPW                   /* enable loopw command         */
 #define CONFIG_MX_CYCLIC               /* enable mdc/mwc commands      */
 #define CONFIG_ZERO_BOOTDELAY_CHECK
-#define CONFIG_AUTOBOOT_KEYED
-#define CONFIG_AUTOBOOT_STOP_STR               " "
-#define CONFIG_AUTOBOOT_PROMPT                 \
-               "Hit SPACE in %d seconds to stop autoboot.\n", bootdelay
 
 #define CONFIG_SYS_MEMTEST_START               0x00800000
 #define CONFIG_SYS_MEMTEST_END                 0x04000000