usb: dwc3: Add DWC3 controller driver support

[u-boot] / include / configs / xaeniax.h

diff --git a/include/configs/xaeniax.h b/include/configs/xaeniax.h
index 28c84db032a65196bf1d55a830a81061201b0e35..a072464c1081837a379215a7fb82abdc53e72dbf 100644 (file)
--- a/include/configs/xaeniax.h
+++ b/include/configs/xaeniax.h
@@ -14,7 +14,7 @@
  *
  * Configuation settings for the xaeniax board.
  *
- * SPDX-License-Identifier:    GPL-2.0+ 
+ * SPDX-License-Identifier:    GPL-2.0+
  */
 
 #ifndef __CONFIG_H
@@ -59,18 +59,14 @@
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_DHCP
 #define CONFIG_CMD_DIAG
-#define CONFIG_CMD_NFS
 #define CONFIG_CMD_SDRAM
 #define CONFIG_CMD_SNTP
 
 #undef CONFIG_CMD_DTT
 
 
-#define CONFIG_ETHADDR         08:00:3e:26:0a:5b
 #define CONFIG_NETMASK         255.255.255.0
 #define CONFIG_IPADDR          192.168.68.201
 #define CONFIG_SERVERIP                192.168.68.62
@@ -84,7 +80,6 @@
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   115200                  /* speed to run kgdb serial port */
-#define CONFIG_KGDB_SER_INDEX  1                       /* which serial port to use */
 #endif
 
 /*
@@ -116,7 +111,6 @@
 
 #define CONFIG_SYS_LOAD_ADDR           0xa1000000      /* default load address */
 
-#define CONFIG_SYS_HZ                  1000
 #define CONFIG_SYS_CPUSPEED            0x141           /* set core clock to 400/200/100 MHz */
 
 /*