at91: defined mach-types for meesc board in board config file

[u-boot] / include / configs / zeus.h

diff --git a/include/configs/zeus.h b/include/configs/zeus.h
index 6136af1fb2c945674d80650f65e3f91ccbf1f414..63279b01ce2133e3df4bdf7c08bbefe7309b74b4 100644 (file)
--- a/include/configs/zeus.h
+++ b/include/configs/zeus.h
@@ -53,7 +53,6 @@
 #define CONFIG_PHY_ADDR                0x01    /* PHY address                  */
 #define CONFIG_HAS_ETH1                1
 #define CONFIG_PHY1_ADDR       0x11    /* EMAC1 PHY address            */
-#define CONFIG_NET_MULTI       1
 #define CONFIG_SYS_RX_ETH_BUFFER       16      /* Number of ethernet rx buffers & descriptors */
 #define CONFIG_PHY_RESET       1
 #define CONFIG_PHY_RESET_DELAY 300     /* PHY RESET recovery delay     */
@@ -253,10 +252,9 @@
 #define CONFIG_SYS_OCM_DATA_ADDR       0xF8000000
 #define CONFIG_SYS_OCM_DATA_SIZE       0x1000
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_OCM_DATA_ADDR /* inside of OCM               */
-#define CONFIG_SYS_INIT_RAM_END        CONFIG_SYS_OCM_DATA_SIZE /* End of used area in RAM     */
+#define CONFIG_SYS_INIT_RAM_SIZE       CONFIG_SYS_OCM_DATA_SIZE /* Size of used area in RAM    */
 
-#define CONFIG_SYS_GBL_DATA_SIZE       128  /* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 /* reserve some memory for POST and BOOT limit info */
 #define CONFIG_SYS_INIT_SP_OFFSET      (CONFIG_SYS_GBL_DATA_OFFSET - 16)
 
@@ -304,14 +302,6 @@
 #define CONFIG_SYS_TIME_POST           5000
 #define CONFIG_SYS_TIME_FACTORY_RESET  10000
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD          0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM          0x02            /* Software reboot                      */
-
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400          /* speed to run kgdb serial port */
 #define CONFIG_KGDB_SER_INDEX  2               /* which serial port to use */