+/* SPDX-License-Identifier: GPL-2.0+ */
/*
* (C) Copyright 2000-2004
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
/*
#ifndef _STATUS_LED_H_
#define _STATUS_LED_H_
-#ifdef CONFIG_STATUS_LED
-
-#define STATUS_LED_OFF 0
-#define STATUS_LED_BLINKING 1
-#define STATUS_LED_ON 2
-
+#ifdef CONFIG_LED_STATUS
+
+#define LED_STATUS_PERIOD (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ)
+#ifdef CONFIG_LED_STATUS1
+#define LED_STATUS_PERIOD1 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ1)
+#endif /* CONFIG_LED_STATUS1 */
+#ifdef CONFIG_LED_STATUS2
+#define LED_STATUS_PERIOD2 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ2)
+#endif /* CONFIG_LED_STATUS2 */
+#ifdef CONFIG_LED_STATUS3
+#define LED_STATUS_PERIOD3 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ3)
+#endif /* CONFIG_LED_STATUS3 */
+#ifdef CONFIG_LED_STATUS4
+#define LED_STATUS_PERIOD4 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ4)
+#endif /* CONFIG_LED_STATUS4 */
+#ifdef CONFIG_LED_STATUS5
+#define LED_STATUS_PERIOD5 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ5)
+#endif /* CONFIG_LED_STATUS5 */
+
+void status_led_init(void);
void status_led_tick (unsigned long timestamp);
void status_led_set (int led, int state);
-/***** TQM8xxL ********************************************************/
-#if defined(CONFIG_TQM8xxL)
-# define STATUS_LED_PAR im_cpm.cp_pbpar
-# define STATUS_LED_DIR im_cpm.cp_pbdir
-# define STATUS_LED_ODR im_cpm.cp_pbodr
-# define STATUS_LED_DAT im_cpm.cp_pbdat
-
-# define STATUS_LED_BIT 0x00000001
-# define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2)
-# define STATUS_LED_STATE STATUS_LED_BLINKING
-
-# define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */
-
-# define STATUS_LED_BOOT 0 /* LED 0 used for boot status */
-
/***** MVS v1 **********************************************************/
-#elif (defined(CONFIG_MVS) && CONFIG_MVS < 2)
+#if (defined(CONFIG_MVS) && CONFIG_MVS < 2)
# define STATUS_LED_PAR im_ioport.iop_pdpar
# define STATUS_LED_DIR im_ioport.iop_pddir
# undef STATUS_LED_ODR
# define STATUS_LED_DAT im_ioport.iop_pddat
-# define STATUS_LED_BIT 0x00000001
-# define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2)
-# define STATUS_LED_STATE STATUS_LED_BLINKING
-
-# define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */
-
-# define STATUS_LED_BOOT 0 /* LED 0 used for boot status */
-
-/***** IVMS8 **********************************************************/
-#elif defined(CONFIG_IVMS8)
-
-# define STATUS_LED_PAR im_cpm.cp_pbpar
-# define STATUS_LED_DIR im_cpm.cp_pbdir
-# define STATUS_LED_ODR im_cpm.cp_pbodr
-# define STATUS_LED_DAT im_cpm.cp_pbdat
-
-# define STATUS_LED_BIT 0x00000010 /* LED 0 is on PB.27 */
-# define STATUS_LED_PERIOD (1 * CONFIG_SYS_HZ)
-# define STATUS_LED_STATE STATUS_LED_OFF
-# define STATUS_LED_BIT1 0x00000020 /* LED 1 is on PB.26 */
-# define STATUS_LED_PERIOD1 (1 * CONFIG_SYS_HZ)
-# define STATUS_LED_STATE1 STATUS_LED_OFF
-/* IDE LED usable for other purposes, too */
-# define STATUS_LED_BIT2 0x00000008 /* LED 2 is on PB.28 */
-# define STATUS_LED_PERIOD2 (1 * CONFIG_SYS_HZ)
-# define STATUS_LED_STATE2 STATUS_LED_OFF
-
-# define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */
-
-# define STATUS_ILOCK_SWITCH 0x00800000 /* ILOCK switch in IRQ4 */
-
-# define STATUS_ILOCK_PERIOD (CONFIG_SYS_HZ / 10) /* about every 100 ms */
-
-# define STATUS_LED_YELLOW 0
-# define STATUS_LED_GREEN 1
-# define STATUS_LED_BOOT 2 /* IDE LED used for boot status */
-
-/***** IVML24 *********************************************************/
-#elif defined(CONFIG_IVML24)
-
-# define STATUS_LED_PAR im_cpm.cp_pbpar
-# define STATUS_LED_DIR im_cpm.cp_pbdir
-# define STATUS_LED_ODR im_cpm.cp_pbodr
-# define STATUS_LED_DAT im_cpm.cp_pbdat
-
-# define STATUS_LED_BIT 0x00000010 /* LED 0 is on PB.27 */
-# define STATUS_LED_PERIOD (1 * CONFIG_SYS_HZ)
-# define STATUS_LED_STATE STATUS_LED_OFF
-# define STATUS_LED_BIT1 0x00000020 /* LED 1 is on PB.26 */
-# define STATUS_LED_PERIOD1 (1 * CONFIG_SYS_HZ)
-# define STATUS_LED_STATE1 STATUS_LED_OFF
-/* IDE LED usable for other purposes, too */
-# define STATUS_LED_BIT2 0x00000008 /* LED 2 is on PB.28 */
-# define STATUS_LED_PERIOD2 (1 * CONFIG_SYS_HZ)
-# define STATUS_LED_STATE2 STATUS_LED_OFF
-
# define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */
-# define STATUS_ILOCK_SWITCH 0x00004000 /* ILOCK is on PB.17 */
-
-# define STATUS_ILOCK_PERIOD (CONFIG_SYS_HZ / 10) /* about every 100 ms */
-
-# define STATUS_LED_YELLOW 0
-# define STATUS_LED_GREEN 1
-# define STATUS_LED_BOOT 2 /* IDE LED used for boot status */
-
/***** Someone else defines these *************************************/
#elif defined(STATUS_LED_PAR)
-
/*
* ADVICE: Define in your board configuration file rather than
* filling this file up with lots of custom board stuff.
*/
-/***** CMI ********************************************************/
-#elif defined(CONFIG_CMI)
-# define STATUS_LED_DIR im_mios.mios_mpiosm32ddr
-# define STATUS_LED_DAT im_mios.mios_mpiosm32dr
-
-# define STATUS_LED_BIT 0x2000 /* Select one of the 16 possible*/
- /* MIOS outputs */
-# define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2) /* Blinking periode is 500 ms */
-# define STATUS_LED_STATE STATUS_LED_BLINKING
-
-# define STATUS_LED_ACTIVE 1 /* LED on for bit == 0 */
-# define STATUS_LED_BOOT 0 /* LED 0 used for boot status */
-
-#elif defined(CONFIG_V38B)
-
-# define STATUS_LED_BIT 0x0010 /* Timer7 GPIO */
-# define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2)
-# define STATUS_LED_STATE STATUS_LED_BLINKING
-
-# define STATUS_LED_ACTIVE 0 /* LED on for bit == 0 */
-# define STATUS_LED_BOOT 0 /* LED 0 used for boot status */
-
-#elif defined(CONFIG_MOTIONPRO)
-
-#define STATUS_LED_BIT ((vu_long *) MPC5XXX_GPT6_ENABLE)
-#define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 10)
-#define STATUS_LED_STATE STATUS_LED_BLINKING
-
-#define STATUS_LED_BIT1 ((vu_long *) MPC5XXX_GPT7_ENABLE)
-#define STATUS_LED_PERIOD1 (CONFIG_SYS_HZ / 10)
-#define STATUS_LED_STATE1 STATUS_LED_OFF
-
-#define STATUS_LED_BOOT 0 /* LED 0 used for boot status */
-
-#elif defined(CONFIG_BOARD_SPECIFIC_LED)
+#elif defined(CONFIG_LED_STATUS_BOARD_SPECIFIC)
/* led_id_t is unsigned long mask */
typedef unsigned long led_id_t;
extern void __led_toggle (led_id_t mask);
extern void __led_init (led_id_t mask, int state);
extern void __led_set (led_id_t mask, int state);
+void __led_blink(led_id_t mask, int freq);
#else
# error Status LED configuration missing
#endif
/************************************************************************/
-#ifndef CONFIG_BOARD_SPECIFIC_LED
+#ifndef CONFIG_LED_STATUS_BOARD_SPECIFIC
# include <asm/status_led.h>
#endif
-#endif /* CONFIG_STATUS_LED */
+#endif /* CONFIG_LED_STATUS */
/*
* Coloured LEDs API