net: keystone_net: use mdio_reset function

Don't use mdio_enable twice while eth open. Also rename it to
keystone2_mdio_reset as more appropriate name.

Acked-by: Vitaly Andrianov <vitalya@ti.com>
Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@ti.com>

diff --git a/drivers/net/keystone_net.c b/drivers/net/keystone_net.c
index 8a45fbd88f835490ac80ed29c954483bf137ce94..3f9650c6ea3ca7939474c46af81ac1343e2a9a34 100644 (file)
--- a/drivers/net/keystone_net.c
+++ b/drivers/net/keystone_net.c
@@ -38,7 +38,6 @@ struct rx_buff_desc net_rx_buffs = {
        .rx_flow        = 22,
 };
 
-static void keystone2_eth_mdio_enable(void);
 static void keystone2_net_serdes_setup(void);
 
 static int gen_get_link_speed(int phy_addr);
@@ -71,7 +70,7 @@ int keystone2_eth_read_mac_addr(struct eth_device *dev)
        return 0;
 }
 
-static void keystone2_eth_mdio_enable(void)
+static void keystone2_mdio_reset(void)
 {
        u_int32_t       clkdiv;
 
@@ -397,7 +396,6 @@ int32_t cpmac_drv_send(u32 *buffer, int num_bytes, int slave_port_num)
 /* Eth device open */
 static int keystone2_eth_open(struct eth_device *dev, bd_t *bis)
 {
-       u_int32_t clkdiv;
        int link;
        struct eth_priv_t *eth_priv = (struct eth_priv_t *)dev->priv;
 
@@ -410,9 +408,6 @@ static int keystone2_eth_open(struct eth_device *dev, bd_t *bis)
 
        keystone2_net_serdes_setup();
 
-       if (sys_has_mdio)
-               keystone2_eth_mdio_enable();
-
        keystone_sgmii_config(eth_priv->slave_port - 1,
                              eth_priv->sgmii_link_type);
 
@@ -440,14 +435,7 @@ static int keystone2_eth_open(struct eth_device *dev, bd_t *bis)
        hw_config_streaming_switch();
 
        if (sys_has_mdio) {
-               /* Init MDIO & get link state */
-               clkdiv = (EMAC_MDIO_BUS_FREQ / EMAC_MDIO_CLOCK_FREQ) - 1;
-               writel((clkdiv & 0xff) | MDIO_CONTROL_ENABLE |
-                      MDIO_CONTROL_FAULT, &adap_mdio->control)
-                       ;
-
-               /* We need to wait for MDIO to start */
-               udelay(1000);
+               keystone2_mdio_reset();
 
                link = keystone_get_link_status(dev);
                if (link == 0) {