]> git.sur5r.net Git - u-boot/commitdiff
mx6sxsabresd: Fix Ethernet PHY reset sequence
authorFabio Estevam <fabio.estevam@freescale.com>
Mon, 23 Nov 2015 18:18:02 +0000 (16:18 -0200)
committerStefano Babic <sbabic@denx.de>
Mon, 7 Dec 2015 13:55:24 +0000 (14:55 +0100)
Since commit 59370f3fcd1350 ("net: phy: delay only if reset handler is
registered") Ethernet is no longer functional.

This commit does not have an issue in itself, but it revelead a problem
with the Ethernet initialization.

Fix this by calling enable_fec_anatop_clock() earlier and also
by adding a 10ms reset delay as recommended in the AR8031 datasheet.

Suggested-by: Jörg Krause <joerg.krause@embedded.rocks>
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Reviewed-by: Stefano Babic <sbabic@denx.de>
board/freescale/mx6sxsabresd/mx6sxsabresd.c

index 3ee46629ee39e782991126c3bfd669f6c3b38729..56dc0208c7d05ca454db4c21023491b71e30f9eb 100644 (file)
@@ -150,11 +150,15 @@ static int setup_fec(void)
 {
        struct iomuxc *iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR;
        struct anatop_regs *anatop = (struct anatop_regs *)ANATOP_BASE_ADDR;
-       int reg;
+       int reg, ret;
 
        /* Use 125MHz anatop loopback REF_CLK1 for ENET1 */
        clrsetbits_le32(&iomuxc_regs->gpr[1], IOMUX_GPR1_FEC1_MASK, 0);
 
+       ret = enable_fec_anatop_clock(0, ENET_125MHZ);
+       if (ret)
+               return ret;
+
        imx_iomux_v3_setup_multiple_pads(phy_control_pads,
                                         ARRAY_SIZE(phy_control_pads));
 
@@ -163,14 +167,14 @@ static int setup_fec(void)
 
        /* Reset AR8031 PHY */
        gpio_direction_output(IMX_GPIO_NR(2, 7) , 0);
-       udelay(500);
+       mdelay(10);
        gpio_set_value(IMX_GPIO_NR(2, 7), 1);
 
        reg = readl(&anatop->pll_enet);
        reg |= BM_ANADIG_PLL_ENET_REF_25M_ENABLE;
        writel(reg, &anatop->pll_enet);
 
-       return enable_fec_anatop_clock(0, ENET_125MHZ);
+       return 0;
 }
 
 int board_eth_init(bd_t *bis)