These files are used by both SPL and main U-Boot.
Signed-off-by: Tom Warren <twarren@nvidia.com>
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Tested-by: Thierry Reding <treding@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>
/*
-* (C) Copyright 2010-2011
+* (C) Copyright 2010-2014
* NVIDIA Corporation <www.nvidia.com>
*
* SPDX-License-Identifier: GPL-2.0+
/*
* This is undocumented, Chip ID is bits 15:8 of the register
* APB_MISC + 0x804, and has value 0x20 for Tegra20, 0x30 for
- * Tegra30, and 0x35 for T114.
+ * Tegra30, 0x35 for T114, and 0x40 for Tegra124.
*/
rev = (readl(&gp->hidrev) & HIDREV_CHIPID_MASK) >> HIDREV_CHIPID_SHIFT;
debug("%s: CHIPID is 0x%02X\n", __func__, rev);
return TEGRA_SOC_T114;
}
break;
+ case CHIPID_TEGRA124:
+ switch (sku_id) {
+ case SKU_ID_T124_ENG:
+ default:
+ return TEGRA_SOC_T124;
+ }
+ break;
}
+
/* unknown chip/sku id */
printf("%s: ERROR: UNKNOWN CHIP/SKU ID COMBO (0x%02X/0x%02X)\n",
__func__, chip_id, sku_id);
* ODMDATA is stored in the BCT in IRAM by the BootROM.
* The BCT start and size are stored in the BIT in IRAM.
* Read the data @ bct_start + (bct_size - 12). This works
- * on T20 and T30 BCTs, which are locked down. If this changes
- * in new chips (T114, etc.), we can revisit this algorithm.
+ * on BCTs for currently supported SoCs, which are locked down.
+ * If this changes in new chips, we can revisit this algorithm.
*/
u32 bct_start, odmdata;
/*
- * (C) Copyright 2010,2011
+ * (C) Copyright 2010-2014
* NVIDIA Corporation <www.nvidia.com>
*
* SPDX-License-Identifier: GPL-2.0+
-1,
-1,
-1,
-#else /* Tegra114 */
+#elif defined(CONFIG_TEGRA114)
-1,
-1,
-1,
FUNCMUX_UART4_GMI, /* UARTD */
-1,
+#else /* Tegra124 */
+ FUNCMUX_UART1_KBC, /* UARTA */
+ -1,
+ -1,
+ FUNCMUX_UART4_GPIO, /* UARTD */
+ -1,
#endif
};
/*
- * Copyright (c) 2013, NVIDIA CORPORATION. All rights reserved.
+ * Copyright (c) 2013-2014, NVIDIA CORPORATION. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify it
* under the terms and conditions of the GNU General Public License,
void config_cache(void)
{
- struct apb_misc_gp_ctlr *gp =
- (struct apb_misc_gp_ctlr *)NV_PA_APB_MISC_GP_BASE;
u32 reg = 0;
/* enable SMP mode and FW for CPU0, by writing to Auxiliary Ctl reg */
"orr r0, r0, #0x41\n"
"mcr p15, 0, r0, c1, c0, 1\n");
- /* Currently, only T114 needs this L2 cache change to boot Linux */
- reg = (readl(&gp->hidrev) & HIDREV_CHIPID_MASK);
- if (reg != (CHIPID_TEGRA114 << HIDREV_CHIPID_SHIFT))
+ /* Currently, only Tegra114+ needs this L2 cache change to boot Linux */
+ if (tegra_get_chip() < CHIPID_TEGRA114)
return;
+
/*
* Systems with an architectural L2 cache must not use the PL310.
* Config L2CTLR here for a data RAM latency of 3 cycles.