Before this change ums mode can not be entered when device
was using the same usb port for usb/uart communication.
Switching USB cable from UART to USB always causes ums exit.
Signed-off-by: Przemyslaw Marczak <p.marczak@samsung.com>
g_dnl_register("ums");
+ /* Timeout unit: seconds */
+ int cable_ready_timeout = UMS_CABLE_READY_TIMEOUT;
+
+ if (!usb_cable_connected()) {
+ puts("Please connect USB cable.\n");
+
+ while (!usb_cable_connected()) {
+ if (ctrlc()) {
+ puts("\rCTRL+C - Operation aborted.\n");
+ goto exit;
+ }
+ if (!cable_ready_timeout) {
+ puts("\rUSB cable not detected.\n" \
+ "Command exit.\n");
+ goto exit;
+ }
+
+ printf("\rAuto exit in: %.2d s.", cable_ready_timeout);
+ mdelay(1000);
+ cable_ready_timeout--;
+ }
+ puts("\r\n");
+ }
+
while (1) {
usb_gadget_handle_interrupts();
#define UMS_NUM_SECTORS 0
#endif
+/* Wait at maximum 60 seconds for cable connection */
+#define UMS_CABLE_READY_TIMEOUT 60
+
struct ums {
int (*read_sector)(struct ums *ums_dev,
ulong start, lbaint_t blkcnt, void *buf);