We need a TLB entry to call get_ram_size(); the common code doesn't create
one until *after* fixed_sdram() has determined the size.  So we set up tlbs
for the max possible size and tear them down once we're done with
get_ram_size(); the common 85xx code will then set up a final set of tlb
entries for the *actual* detected size of ddr.
This prevents us from having TLB entries that are larger than DDR sitting
around for very long, which is not a recommended scenario.
Signed-off-by: Becky Bruce <beckyb@kernel.crashing.org>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
        udelay (1000);
 #endif /* CONFIG_TQM8548 */
 
+       /*
+        * get_ram_size() depends on having tlbs for the DDR, but they are
+        * not yet setup because we don't know the size.  Set up a temp
+        * mapping and delete it when done.
+        */
+       setup_ddr_tlbs(CONFIG_SYS_DDR_EARLY_SIZE_MB);
        for (i = 0; i < N_DDR_CS_CONF; i++) {
                ddr->cs0_config = ddr_cs_conf[i].reg;
 
                        break;
                }
        }
+       clear_ddr_tlbs(CONFIG_SYS_DDR_EARLY_SIZE_MB);
 
 #ifdef CONFIG_TQM8548
        if (i < N_DDR_CS_CONF) {
 
  * DDR Setup
  */
 #define CONFIG_SYS_DDR_SDRAM_BASE      0x00000000      /* DDR is system memory */
+
 #if defined(CONFIG_TQM_BIGFLASH) || \
        (!defined(CONFIG_TQM8548_AG) && !defined(CONFIG_TQM8548_BE))
 #define CONFIG_SYS_PPC_DDR_WIMGE (MAS2_I | MAS2_G)
+#define CONFIG_SYS_DDR_EARLY_SIZE_MB   (512)
+#else
+#define CONFIG_SYS_PPC_DDR_WIMGE (0)
+#define CONFIG_SYS_DDR_EARLY_SIZE_MB   (2 * 1024)
 #endif
+
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 #ifdef CONFIG_TQM8548_AG
 #define CONFIG_VERY_BIG_RAM