ColdFire: Relocate vector table - mcf5445x

Newer ColdFire processors family boot from address 0 instead of
0xFFnn_nnnn. When the boot flash base chip select is set at new
location instead of 0, an un-predictable error will occur if
there is an vector being trigger and refer it to an invalid
address or the vector table handler is not existed at address
0.

Signed-off-by: TsiChung Liew <tsicliew@gmail.com>

diff --git a/cpu/mcf5445x/cpu_init.c b/cpu/mcf5445x/cpu_init.c
index 00e0ca6da92892d9abbc3fa11bb22979e711a233..8d51d35d685353b060ee1bfb4c1fa0f5e315cfa8 100644 (file)
--- a/cpu/mcf5445x/cpu_init.c
+++ b/cpu/mcf5445x/cpu_init.c
@@ -28,6 +28,7 @@
 #include <common.h>
 #include <watchdog.h>
 #include <asm/immap.h>
+#include <asm/processor.h>
 #include <asm/rtc.h>
 
 #if defined(CONFIG_CMD_NET)
@@ -105,6 +106,14 @@ void cpu_init_f(void)
        fbcs->csmr5 = CONFIG_SYS_CS5_MASK;
 #endif
 
+       /*
+        * now the flash base address is no longer at 0 (Newer ColdFire family
+        * boot at address 0 instead of 0xFFnn_nnnn). The vector table must
+        * also move to the new location.
+        */
+       if (CONFIG_SYS_CS0_BASE != 0)
+               setvbr(CONFIG_SYS_CS0_BASE);
+
 #ifdef CONFIG_FSL_I2C
        gpio->par_feci2c = GPIO_PAR_FECI2C_SCL_SCL | GPIO_PAR_FECI2C_SDA_SDA;
 #endif