Pull the serial port configuration from DT and use DM serial instead
of having the serial configuration in two places, DT and board config.
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Chin Liang See <chin.liang.see@intel.com>
Cc: Dinh Nguyen <dinguyen@kernel.org>
select ARCH_MISC_INIT
select CPU_V7A
select DM
+ select DM_SERIAL
select ENABLE_ARM_SOC_BOOT0_HOOK
select OF_CONTROL
select SPL_LIBCOMMON_SUPPORT
select SPL_NAND_SUPPORT if SPL_NAND_DENALI
select SPL_OF_CONTROL
select SPL_SERIAL_SUPPORT
+ select SPL_DM_SERIAL
select SPL_SPI_FLASH_SUPPORT if SPL_SPI_SUPPORT
select SPL_SPI_SUPPORT if DM_SPI
select SPL_WATCHDOG_SUPPORT
select SUPPORT_SPL
select SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION_TYPE
+ select SYS_NS16550
select SYS_THUMB_BUILD
imply CMD_MTDPARTS
imply CRC32_VERIFY
reg-shift = <2>;
reg-io-width = <4>;
clocks = <&l4_sp_clk>;
+ clock-frequency = <100000000>;
};
uart1: serial1@ffc03000 {
reg-shift = <2>;
reg-io-width = <4>;
clocks = <&l4_sp_clk>;
+ clock-frequency = <100000000>;
};
rst: rstmgr@ffd05000 {
};
&uart1 {
+ clock-frequency = <50000000>;
u-boot,dm-pre-reloc;
status = "okay";
};
* Serial Driver
*/
#define CONFIG_SYS_NS16550_SERIAL
-#define CONFIG_SYS_NS16550_REG_SIZE -4
-#if defined(CONFIG_TARGET_SOCFPGA_GEN5)
-#define CONFIG_SYS_NS16550_COM1 SOCFPGA_UART0_ADDRESS
-#define CONFIG_SYS_NS16550_CLK 100000000
-#elif defined(CONFIG_TARGET_SOCFPGA_ARRIA10)
-#define CONFIG_SYS_NS16550_COM1 SOCFPGA_UART1_ADDRESS
-#define CONFIG_SYS_NS16550_CLK 50000000
-#endif
/*
* USB