usb: ehci-mx6: configure power polarity in usb_power_config

USBNC_n_CTRL1 bit 9 actually controls the power pin polarity.
Rename UCTRL_PM to align reference manual and set the bit in
the appropriate callback usb_power_config.

Signed-off-by: Stefan Agner <stefan.agner@toradex.com>

diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
index 069f116ed2de0e18aa4d0286e47ce7afd180bf82..277f4616464955aa7a29aee6e9473e3236658d6a 100644 (file)
--- a/drivers/usb/host/ehci-mx6.c
+++ b/drivers/usb/host/ehci-mx6.c
@@ -49,7 +49,7 @@
 #define USBNC_OFFSET           0x200
 #define USBNC_PHYSTATUS_ID_DIG (1 << 4) /* otg_id status */
 #define USBNC_PHYCFG2_ACAENB   (1 << 4) /* otg_id detection enable */
-#define UCTRL_PM                (1 << 9) /* OTG Power Mask */
+#define UCTRL_PWR_POL          (1 << 9) /* OTG Polarity of Power Pin */
 #define UCTRL_OVER_CUR_POL     (1 << 8) /* OTG Polarity of Overcurrent */
 #define UCTRL_OVER_CUR_DIS     (1 << 7) /* Disable OTG Overcurrent Detection */
 
@@ -207,12 +207,16 @@ static void usb_power_config(int index)
        struct usbnc_regs *usbnc = (struct usbnc_regs *)(USB_BASE_ADDR +
                        (0x10000 * index) + USBNC_OFFSET);
        void __iomem *phy_cfg2 = (void __iomem *)(&usbnc->phy_cfg2);
+       void __iomem *ctrl = (void __iomem *)(&usbnc->ctrl1);
 
        /*
         * Clear the ACAENB to enable usb_otg_id detection,
         * otherwise it is the ACA detection enabled.
         */
        clrbits_le32(phy_cfg2, USBNC_PHYCFG2_ACAENB);
+
+       /* Set power polarity to high active */
+       setbits_le32(ctrl, UCTRL_PWR_POL);
 }
 
 int usb_phy_mode(int port)
@@ -250,11 +254,7 @@ static void usb_oc_config(int index)
        setbits_le32(ctrl, UCTRL_OVER_CUR_POL);
 #endif
 
-#if defined(CONFIG_MX6)
        setbits_le32(ctrl, UCTRL_OVER_CUR_DIS);
-#elif defined(CONFIG_MX7)
-       setbits_le32(ctrl, UCTRL_OVER_CUR_DIS | UCTRL_PM);
-#endif
 }
 
 /**