serial: ns16550: Remove unnecessary init on UART setup

It is not necessary to write a zero baud rate to the device, and for some
chips this will cause problems. Drop this code.

Signed-off-by: Simon Glass <sjg@chromium.org>

diff --git a/drivers/serial/ns16550.c b/drivers/serial/ns16550.c
index 61312995fb86e6c93b259c4803c8658b48b16c4a..fd110b3ddcdf1514a738294ebf4f423bfc254437 100644 (file)
--- a/drivers/serial/ns16550.c
+++ b/drivers/serial/ns16550.c
@@ -175,7 +175,6 @@ void NS16550_init(NS16550_t com_port, int baud_divisor)
                        defined(CONFIG_TI81XX) || defined(CONFIG_AM43XX)
        serial_out(0x7, &com_port->mdr1);       /* mode select reset TL16C750*/
 #endif
-       NS16550_setbrg(com_port, 0);
        serial_out(UART_MCRVAL, &com_port->mcr);
        serial_out(UART_FCRVAL, &com_port->fcr);
        if (baud_divisor != -1)