sheevaplug: correct SDRAM address control register

value

The SheevaPlug DevKit is shipped with 4x8 by 1Gb DDR devices in
two banks for a total of 512MB of RAM. Based on this configuration
the existing values for SDRAM address control register are incorrect
and result in random kernel oops as memory is incorrectly accessed
(while for example extracting a large tarball such as a rootfs).
Based on the hardware configuration along with the supporting
documentation from Marvell these are the correct values, as
well this change mimics values previously used in Marvell's own
u-boot git tree for the SheevaPlug.

Other variants of the hardware such as the PogoPlug and TonidoPlug
may have different memory configurations but to properly support
those additional board directories should be maintained or a better
system to support other kwb*.cfg is needed.

Tested on SheevaPlug DevKit.

Signed-off-by: Mark Asselstine <mark.asselstine@windriver.com>

diff --git a/board/Marvell/sheevaplug/kwbimage.cfg b/board/Marvell/sheevaplug/kwbimage.cfg
index 6c47d6267b992d7db3bf1c781ba6a4c9f49068bf..3b9c53f57f2e99acb43b52683d5611faf80c6a77 100644 (file)
--- a/board/Marvell/sheevaplug/kwbimage.cfg
+++ b/board/Marvell/sheevaplug/kwbimage.cfg
@@ -74,11 +74,11 @@ DATA 0xFFD0140C 0x00000a33  #  DDR Timing (High)
 # bit12-11: TW2W
 # bit31-13: zero required
 
-DATA 0xFFD01410 0x00000099     #  DDR Address Control
-# bit1-0:   01, Cs0width=x16
-# bit3-2:   10, Cs0size=512Mb
-# bit5-4:   01, Cs1width=x16
-# bit7-6:   10, Cs1size=512Mb
+DATA 0xFFD01410 0x000000cc     #  DDR Address Control
+# bit1-0:   00, Cs0width=x8
+# bit3-2:   11, Cs0size=1Gb
+# bit5-4:   00, Cs1width=x8
+# bit7-6:   11, Cs1size=1Gb
 # bit9-8:   00, Cs2width=nonexistent
 # bit11-10: 00, Cs2size =nonexistent
 # bit13-12: 00, Cs3width=nonexistent