For all the UniPhier SoCs so far, the reset signal of the NAND core
is automatically deasserted after the PLL gets stabled.
(The bit 2 of SC_RSTCTRL is default to one.)
This causes a fatal problem on the NAND controller of PH1-LD4.
For that SoC, the NAND I/O pins are not set up yet at the power-on
reset except the NAND boot mode. As a result, the NAND controller
begins automatic device scanning with wrong I/O pins and finally
hangs up.
Actually, U-Boot dies after printing "NAND:" on the console unless
the boot mode latch detected the NAND boot mode.
To work around this problem, reset the NAND core in SPL for non-NAND
boot modes. If CONFIG_NAND_DENALI is enabled, the reset signal is
deasserted again in U-Boot proper. At this time, I/O pins have been
correctly set up, the device scanning should succeed.
Signed-off-by: Masahiro Yamada <yamada.m@jp.panasonic.com>
* SPDX-License-Identifier: GPL-2.0+
*/
+#include <common.h>
+#include <spl.h>
#include <asm/io.h>
#include <mach/sc-regs.h>
/* deassert reset */
tmp = readl(SC_RSTCTRL);
+
tmp |= SC_RSTCTRL_NRST_UMC1 | SC_RSTCTRL_NRST_UMC0;
+ if (spl_boot_device() != BOOT_DEVICE_NAND)
+ tmp &= ~SC_RSTCTRL_NRST_NAND;
writel(tmp, SC_RSTCTRL);
readl(SC_RSTCTRL); /* dummy read */